Table of Contents
Advertisement
Section - Frequently Asked Questions
The recommended player is installed, but it still doesn't work?
Check to see if DirectDraw is enabled.
1. Open Windows
2. Wait for the diagnostic to run.
3. Click on the Video 2 tab, which should correspond to the PC-on-TV device.
If DirectDraw is disabled, click on the Enable button. The DirectDraw players such as PowerDVD should now work.
Can the Internet be accessed while projecting through the PC-on-TV device?
The Internet can be accessed either through the computer, the PC-on-TV device, or a wireless access point (if one
already exists while being projected onto the display).
If the Internet is accessed via the PC-on-TV device, it is advised that the Ethernet cable be connected to the PC-on-TV
device before it is powered up.
Note the following special cases:
• The Ethernet port on the board can have DHCP enabled or STATIC addresses. This can be accomplished from
within the PC-on-TV device application.
• Port 80 should be open on the LAN to allow access to the Internet.
• Port 21 should be open on the LAN to allow PC-on-TV device firmware updates.
• The DHCP allocation range is 10.0.0.2 through 10.0.0.254 (IP/subnet of PC-on-TV device Ethernet port should
be different than 10.0.0.x).
• The PC-on-TV device Ethernet port has a 'dummy' MAC address by default. During the manufacturing process,
each device is programmed with a unique MAC address. This is necessary to avoid MAC address conflict and
improper operation of the device. Note that with a dummy MAC address, there may be some computers which
may not be able to connect to the device.
D-Link DPG-100 User Manual
Start, Run, and type: dxdiag
®
Advertisement
Table of Contents
