Led Control - D-Link DCS-1000 Manual

The default setting for the Encryption Key is Disable. Therefore, to secure the
wireless transmission be sure to Enable the Encryption Key by entering the
relevant data.
Note:
Carefully input the Encryption Code, any error setting the code will cause the
communication link to fail.

LED Control:

The LED control allows you to setup the LED illumination as desired. This
feature provides the flexibility when surveillance activity is ON.
There are three options as follows:
Normal
Power - Steady On of the LED indicator.
LAN/WLAN - Steady On of the LED indicator. When LAN/WLAN
activity is present the LED indicator will flash steadily.
OFF
Power - LED indicator is off
LAN/WLAN – LED indicator is off
Dummy
Power - Steady On of the LED indicator.
LAN/WLAN -
flashing.
Note: The WLAN LED is only available on the Wireless Internet
Camera
The default setting for the LED control is Normal. When you have configured
the LED control the correct illumination will set in after 1 minute.
Note:
This function is built-in to the LED indicators to add extra capabilities. The three
options allow the Administrator to configure and camouflage the illumination for
the LED indicator to falsify the monitoring status. In Normal Mode the LED
indicator functions normally. Under Off Mode the LED indicators are both off,
however, it is still monitoring the activity. In Dummy Mode the LED indicators
operate in monitoring condition but monitoring activity is off or on.
Loading ActiveX From:
This field is used to specify the location of Xplug Control (ActiveX) plug-in
program. Enter the information as required in .ocx format, for example:
http://www.<your company>.com/xplug.ocx where <your company> must
be replaced with your company's DNS server.
22
Steady On of the LED indicator with random