Hardware Installation - D-Link DCS-1000 Manual

Hardware Installation

1. Attach Wireless Antenna (Wireless
Internet Camera only)
From the rear panel of the Internet Camera,
screw the 2 external antennas that came with
DCS-1000W into the antenna connector.
2. Configure Network Communication
(Wireless Internet Camera only)
From the rear panel of the Internet Camera select
the desired network communication for the Internet
Camera from the Slide Switch. Position the Slide
Switch to the setting required for either LAN or LAN/
WLAN (Wireless Internet Camera only) position.
Please refer to the Physical Description section
for detailed information.
3. Connect an Ethernet cable
Connect an Ethernet cable to the network
cable connector located on the Internet
Camera's rear panel and attach it to the
network.
4. Attach the external power supply
Attach the external power supply to the DC power
input connector located on the Internet Camera's
rear panel and labeled DC 5V and connect it to
your local power supply.
Note:
The LED indicator labeled Power will illuminate to
indicate a proper connection to the power supply.
9