Sharp QT-CD250 Operation Manual page 8

<P=003>
(Continued)
REPEAT STOP
BAND TUNING
REVIEW
PRESET
/
PRESET
BAND
APSS (Auto Program Search System)
APSS automatically locates the beginning of any
track.
To listen again to the track being played:
Press the DOWN ( ) button for less than 0.5
3 / 5
seconds during playback.
To move to the beginning of the next track:
Press the UP ( ) button for less than 0.5
2 / 4
seconds during playback.
Notes:
To skip a number of tracks at one time, press the
UP ( ) or DOWN (
2 / 4
repeatedly until the desired track number is
shown.
To start playing at a desired track, press the UP
( ) or DOWN (
2 / 4 3 / 5
the stop mode to select the track number, and
then press the PLAY/PAUSE (
Repeat play
PLAY / PAUSE
TUNING
During playback, press the REPEAT/BAND (
ton repeatedly to select the play mode.
Each time the button is pressed, the display will
change as follows:
CUE
PRESET
TUNING
/
PRESET
TUNING
Note:
When using repeat play, be sure to press the
STOP ( ) button after you are through listening.
Otherwise, the CD(s) will play continuously.
Cue and review
1
Load a disc and begin playback.
2
Hold down the CUE (
fast forward, and hold down the REVIEW (
) button for audible fast reverse.
5
3
Normal playback will resume when the REVIEW
(
3 / 5
Notes:
When the end of the disc is reached while
cueing, "End" will appear in the display and CD
operation is paused. Press the REVIEW (
) button ) button for fast reverse or press the STOP
3 / 5 5
( ) button to stop CD operation.
If the beginning of the disc is reached while
reviewing, the mode will automatically switch to
) button while in normal playback at that point.
) button.
0 6
7
QT-CD250(SEC) TINSE0040SJZZ
Flash 1 track repeat play
Appear All track repeat play
Disappear
Normal play
Repeat play indicator
) button for audible
2 / 4
) or CUE ( ) button is released.
2 / 4
) but-
R
3 /
3 /