First Time Setup; Speaker Settings - Onkyo TXNR905B Instruction Manual

First Time Setup

This section explains the settings that you need to make before using the AV receiver for the very first time.

Speaker Settings

GAME/TV AUX 1
If you change these settings, you must run the auto- 4 5
TAPE TUNER
matic speaker setup again (see page 61).
7 8
PHONO NET/USB
+10 0
--/--- 10
INPUT SELECTOR
MACRO
1 2
REMOTE MODE
DVD VCR
TV CABLE
SAT
DIMMER
2, 3
+
CH
ENTER
DISC
ALBUM
-
1, 6
PREV
CH
DISPLAY
REC
PLAYLIST
SP A
If the impedance of any speaker is 4 ohms or more but
less than 6, set the Speaker Impedance to 4 ohms.
To use bi-amping or bridging, you must change the
Speaker Type setting. For hookup information, see pages
27–30.
Notes:
• When bridging is used, the AV receiver is able to drive
up to 2.1 speakers in the main room.
• When bi-amping is used, the AV receiver is able to
drive up to 5.1 speakers in the main room.
• Before you change these settings, turn down the vol-
ume.
1 Press the [RECEIVER] button,
followed by the [SETUP] button.
RECEIVER
The main menu appears onscreen.
2
Use the Up and Down [
buttons to select "2. Speaker
Setup," and then press [ENTER].
ENTER
The Speaker Setup menu appears.
ENTER
AUX 2 TV CH
-
6
CD
9
TV VOL
D. TUN
CLEAR
11 12
3 3
ZONE
CD ZONE 2
CDR/MD/DOCK
1
NET/USB RECEIVER
TAPE/AMP
SLEEP
2–5
VOL
MUTING
RANDOM
SP B
]/[ ]
3
Use the Up and Down [
buttons to select "1. Speaker Set-
tings," and then press [ENTER].
ENTER
The Speaker Settings menu appears.
2-1.Speaker Settings
Speaker Impedance
Front(Speaker A)
Front(Speaker B)
ENTER
4
Use the Up and Down [
buttons to select "Speaker
Impedance," and use the Left and
ENTER
Right [ ]/[
4 ohms: Select if the impedance of any
speaker is 4 ohms or more but
less than 6.
6 ohms: Select if the impedances of all
speakers are between 6 and
16 ohms.
5
Use the Up and Down [
buttons to select "Front (Speaker
A)," and use the Left and Right
ENTER
[ ]/[ ] buttons to select:
Normal: Select this if you've con-
nected your front Speakers A
normally.
Bi-Amp:Select this if you've con-
nected your front Speakers A
for bi-amped operation.
BTL: Select this if you've con-
nected your front Speakers A
for bridged operation. The
BTL indicator will appear on
the display.
Note:
• Bi-Amp and BTL cannot be selected
if Front (Speaker B) is set to Bi-Amp
or BTL.
]/[ ]
6ohms
Normal
Not use
]/[ ]
] buttons to select:
]/[ ]
51