Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for diLUSSO CE528BP
Summary of Contents for diLUSSO CE528BP
- Page 1 Undermount Rangehood CE528MP CE528BP CE728MP CE928MP CE928BP Installa on and Opera on Manual To avoid the risk of accident or damage to the appliance, it is essential to read the following instructions prior to product installation and / or first time usage.
-
Page 2: Table Of Contents
CONTENTS Important Note ————–‐———————————————————Page 3 Product Specifica on ———–——————————————————Page 6 Installa on Instruc on ——————–—‐—————————————Page 8 Ducted mode ——————‐————–—————————————Page 14 Recircula on mode ——–——————–‐————————————‐Page 16 Electrical Connec on ———————————————–‐—————Page 17 Rangehood Opera on & Control ————————————————Page 18 Cleaning and Maintenance ———–——–‐——————–‐—————Page 19 Troubleshoo ng ———————–——‐—————————————Page 21 Schema c Diagram——————————————————————Page 22 ... -
Page 3: Important Note
Important Notes Dear Customer Thank you for choosing our product. This appliance is easy to use; however please read this handbook carefully before installing and opera ng it. Herein, you will find the correct method of installa on and ps for best use and maintenance of the product. This appliance is designed to be handy for any adult to use at home. Do not allow children to play with it. Children need to be supervised when the product is in opera on so that they do not go near the range hood. - Page 4 Packaging cling film, polystyrene and plas c wrappings must be kept out of reach of babies and young children to avoid suffoca on. Do not connect the appliance if there are obvious signs of transporta on damage. If the supply cord is damage, it must be replaced by the manufacturer, or its service agent as men oned in Clause 7 (60335‐2‐31) Ensure the loca on in which this appliance is installed has good, permanent ven la on.
- Page 5 This appliance is not intended for use by person (including children) with reduced physical, sensory or mental capabili es or lack of experience and knowledge. Unless, they have been given supervision or instruc on regarding the use of appliance by personnel who is responsible for their safety. There is risk of catching fire if cleaning is not carried out in accordance with the frequency suggested and instruc ons ...
-
Page 6: Product Specifica On
Product Specifica on CE528MP/CE528BP CE728MP 220‐240Vac / 50Hz Voltage / Frequency : 220‐240Vac / 50Hz 293 W Rated Power : 293 W 800m /hr Air Flow : 800m 290W Motor Power : 290W Aluminium or Filter : Aluminium or Charcoal (Op onal) Charcoal (Op onal) LED light 1.5W x 2 Ligh ng : LED light 1.5W x 2 3 speed Speed Se ngs : 3 speed Ducted or Duc ng ... - Page 7 External Dimension : CE528MP/CE528BP CE728MP CE928MP/CE928BP Complete product comes with the following : 1 x rangehood body 1 x user manual & warranty card Fixing screws...
-
Page 8: Installa On Instruc On
Installa on Instruc on Mount the rangehood to the bo om panel of a kitchen cabinet. The lower part of the hood must be located at a minimum height of 650mm above any cooker hob. The range hood installa on shall comply with 650mm or the distance specified in the cooker hob instruc on manual, whichever is higher. Any installa on above 750mm will compromise the range hood performance. When the hood is working at the same me with other non‐electrical cooking equipment, the nega ve pressure of the room must not exceed 4Pa. ... - Page 9 Cabinet cutout dimensions : Dimension Model L1 CE528MP/CE528BP 497mm CE728MP 677mm CE928MP/CE928BP 865mm ...
- Page 10 Installa on Steps 1. Remove the metal filter. 2. Remove the stainless steel frame by unfastening 4 pcs of M4*10 screws. and CE928MP model unfastening the other 2 screws (M4*8).
- Page 11 3. Unfastening ST4*10 of the terminal box, remove the lid of the terminal box, disconnect the control board wires. Disconnect the LED light wires. 4. Fix the rangehood to the cabinet cutout by using 12 pcs of ST4*18 screws.
- Page 12 5. Put the stainless steel frame back into place and fasten the screws removed just now. 6. Reconnect the control board and LED lights wires in the terminal box. Close the terminal box lid and secure it with the ST4*10 screw.
- Page 13 7. Put the metal filter back into place. 8. Install the 150mm duct pipe (op onal)
-
Page 14: Ducted Mode
Ducted mode (Vented mode) In the ducted mode, air is drawn into the hood. Oil is trapped in the aluminium filter while odours, fumes and condensa on are then directed and vented to the outside. Only the aluminium filters is to be installed in the ducted mode. Ductwork should be planned carefully before drilling and cu ng the duct. Installer must ensure that the product installa on and connec on complies with the local and general duc ng regula on in force. Flexible ductwork is recommended. Extend duct to its full length, and posi on, cut and discard any excess. ... - Page 15 Note : Keep duct as straight as possible for maximum air flow and at least restric ons, while providing for easy maintenance. Vented system must be terminated to the outside. Ductwork can extend either through the wall or the roof. Do not terminate the vent system in an a c or other enclosed area. The length of the ductwork and the number of elbows should be kept to minimum ...
-
Page 16: Recircula On Mode
Recircula on mode In the recircula on mode, air is drawn into the hood. Oil is trapped in the aluminium filters while cooking odours is removed by the charcoal filter. Purified air then is directed back to the kitchen. In this mode, charcoal filter is strongly recommended to be fi ed to the rangehood. ... -
Page 17: Electrical Connec On
Electrical Connec on Before connec ng to the mains, make sure that : The electric meter, fuse, feeding line and socket are adequate to withstand the maximum load required (refer to product data label for rated power) The supply system is regularly earthed, according to the regula ons in force. The isola on switch can easily be reached a er the rangehood is installed. -
Page 18: Rangehood Opera On & Control
Rangehood Opera on & Control The hood is equipped with a 3‐speed control motor. Electronic control bu ons are located at the front edge of the hood canopy. To achieve be er results, it is recommended to switch the hood on 3 to 5 mins before cooking starts. Likewise, let the hood run for a few minutes a er cooking. Light On / Off To turn the ligh ng system on and off. Fan at Low Speed To turn the extractor motor On at low speed. This mode provides a con nuous and low volume extrac on in the presence of light cooking vapours. Fan at Medium Speed To turn the extractor motor On at medium speed. Suitable for most opera ng condi ons. This mode provides the op mum treated air flow to noise level ra o. Fan at High Speed To turn the extractor motor On at high speed. Suitable for elimina ng ... -
Page 19: Cleaning And Maintenance
Cleaning & Maintenance Cau on: Prior to cleaning or maintenance, always disconnect the power supply. Do not use a steam cleaner. To ensure the range hood is func oning effec vely, regular maintenance is a must. Surfaces : Clean with warm soapy water and a so sponge. Never use abrasive detergent, scouring pads, steel wool or solvents on any part of this appliance as this ... - Page 20 Charcoal Filter : Charcoal filter is not washable. To change the charcoal filter, first remove the metal filter, then loosen and remove the charcoal filter as indicated in diagram below. Get a pair of new charcoal filter and ghten them to fit to the side of extractor motor in the opposite direc on. LED replacement: Contact authorised seller for replacement part. Remove the met‐ al filter and push the LED from inside the hood body to remove the LED. Disconnect the LED wires and replace the connec on with a new LED. Push the LED from outside the rangehood body to fix it to the lamp hole. Max Power Voltage Picture Lamp Cap ILCOS D code Round/ Diameter —— 1.5W DC 12 V DSR-1.5-S-70 : 70mm...
-
Page 21: Troubleshoo Ng
Troubleshoo ng Scenario Possible Causes Solu on Motor does not work No power supply Ensure the appliance is connected to mains properly Reset the circuit breaker Lights On, but motor Foreign object blocked the Contact the service agent does not work fan blade Capacitor or motor is Contact the service agent damaged Poor Airflow Metal filter is clogged Clean the filter and refit it a er it is dry Motor is running but Bu erfly valve is jammed Contact the service agent there is no airflow Motor cuts out a er a High temperature safety Check if the kitchen few minutes device is ac vated ven la on is good and sufficient ... -
Page 22: Schema C Diagram
Schema c diagram AC INPUT Light... - Page 24 P/N:16173000A22058...
Need help?
Do you have a question about the CE528BP and is the answer not in the manual?
Questions and answers