Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Frigidaire FRA08EZT10
Summary of Contents for Frigidaire FRA08EZT10
- Page 1 FRIGIDAIRE Packac Air Conditioner Feai...
- Page 2 This USE & CARE MANUAL provides specific operating instructions for your model. Use the room air conditioner only as instructed in this USE & CARE MANUAL. These instructions are not meant to cover every possible condition and situation that may occur. Common sense and caution must be practiced when installing, operating, and maintaining any appliance.
-
Page 3: Product Registration
Model No, Serial No Register Your Product The self-addressed PRODUCT REGISTRATION CARD should be filled in completely, signed and returned to the Frigidaire Company. Packaging Remove all packaging from inside the carton,... -
Page 4: Air Conditioner
Warning: Do not mix old and new batteries. Do not mix [ZZ] ..CC3,,o°/ alkaline, standard (carbon-zinc), or rechargeable (nickel- heater cadmium batteries. FRIGIDAIRE FOR HEAT MODELS STANDARD REMOTE w/DISPLAY & REMOTESENSING BUTTON Operating Instructions The following instructions... - Page 5 Operating Instructions (continued) TO CHANGE TEMPERATURE SETrlNG; YOU WILL SEE: tamp/timer temp/timer auto auto hi [] DO THIS: reed PRESS A TO RAISE PRESS V TO LOWER Note: Tap or hold either up ( A ) or down ( V ) button until the desired temperature is seen on the display.
-
Page 6: To Operate On Fan Only
Operating Instructions (continued) TO OPERATE ON FAN ONLY: YOU WILL SEE; temp/timer temp/timer heat heat cool cool DO THIS: energy saver energy saver PRESS fan only fan only MODE BUTTON CHOOSE FAN ONLY Note: Use this function only when cooling is not desired, such as for room air circulation or to exhaust... - Page 7 Operating Instructions (continued) CHECK FILTER FEATUREr YOU WILL SEE: temp/timer temp/timer heat heat cool cool [] energy saver [] energy saver Dn only fen only PRESS FILTER DO THIS: --L_ RESET BUTTON Note: This feature is a reminder to clean the Air Filter (See Care and Cleaning) for more efficient operation. The LED (light) will illuminate after 250 hours of operation.
-
Page 8: Remote Sensing
If the display reads "HS", a sensor has If the display reads "AS", a sensor has If the display reads "ES", a sensor has failed. Contact your Authorized Frigidaire failed. Contact your Authorized Frigidaire failed. Contact your Authorized Frigidaire Service Center. - Page 9 Operating Instructions (continued) YOU WILL SEE; TO CHANGE TEMPERATURE DISPLAY: temp/timer DO THIS: PRESSAND HOLD THE UP/DOWN BUTTONS TOGETHER FOR 3 SECONDS Note: The control is capable of displaying temperature in degrees Fahrenheit or degrees Celsius. TO TURN UNIT OFF: YOU WILL SEE: hi m reed...
-
Page 10: Care And Cleaning
Operating Instructions (continued) The louvers will allow you to direct the air flow Up or Down and Left or Right throughout the room as needed. Rotate the Auger Wheel until the desired direction is obtained. AUGER WHEEL Clean your air conditioner occasionally to keep it looking new. Be sure to unplug Care and Cleaning the unit before cleaning to prevent shock or fire hazards, Air Filter Cleaning... - Page 11 Increase set temperature. Remote Sensing activated (on some models) and remote control located in Hot Spot - Relocate remote control or deactivate remote sensing. If These Solutions Fail, Call 1=800=944=9044 For Frigidaire Service, 02009 Electrolux Home Products, Inc. All rights reserved.
- Page 12 Your appliance is covered by a full one-year warranty and a limited 2-5 year warranty(sealed system). For one year from your original date of purchase, Electrolux will pay all costs for repairing or replacing any parts of this appliance that prove to be defective in materials or workmanship when such appliance is installed, used and maintained in accordance with the provided instructions.