Bissell CleanView II User Manual page 14

Troubleshooting Continued
Vacuum cleaner won't pick up dirt continued
Possible Causes
Dirt Container not installed properly
10
Filters are dirty
11
Louvers missing or installed incorrectly
12
Tools won't pick up dirt
Possible Cause
Crack or hole in Hose
1
Clog in vacuum
2
Dirt Container full
3
Dirt Container or Upper Tank
4
not installed properly
Filters are dirty
5
Louver missing or installed incorrectly
6
Vacuum cleaner is difficult to push
Possible Causes
Incorrect Height Adjustment
1
Brush Cover installed incorrectly
2
Visible dirt escaping from cleaner
Possible Causes
Dirt Container full
1
Filters missing or installed incorrectly
2
Dirt Container installed incorrectly
3
Filter Cup installed incorrectly
4
If suggested solutions do not correct the problem, call:
BISSELL Consumer Services
Remedies
Position correctly and lock in place
10
Check and clean Inner and Outer
11
Circular Filters, Pre-Motor and
Post-Motor Filters
Check for a clog in the tube in the
12
center of the Dirt Container, clear
and properly install Louvers
Remedies
Check Hose and replace if needed
1
Clear clog, see pg. 11-12
2
Empty Dirt Container
3
Position correctly and
4
lock in place
Check and clean Inner and Outer
5
Circular filters, Pre-Motor and
Post-Motor Filters
Check for a clog in the tube in the
6
center of the Dirt Container, clear
and properly install Louvers
Remedies
Adjust Powerfoot to correct
1
height setting
Make sure all four screws are in
2
place or all three latches are secured
Remedies
Empty Dirt Container
1
Check Inner and Outer Circular
2
Filters and Post-Motor Filter for
correct installation
Pull out and re-insert Dirt
3
Container correctly
Remove Dirt Container and make
4
sure Filter Cup is fully attached
13