Download Table of Contents Print this page

Indoor Unit; Installation Of The Indoor Unit - Haier HSU-09LH13 Installation Manual

User manual
Hide thumbs Also See for HSU-09LH13:

Advertisement

Table of Contents

Indoor unit

1.Fitting of the Mounting Plate and Positioning of the wall Hole
When the mounting plate is first fixed
1.Carry out, based on the neighboring pillars or lintels, a proper leveling for the plate to be
fixed against the wall, then temporarily fasten the plate with one steel nail.
2. Make sure once more the proper level of the plate, by hanging a thread with a weight from
the central top of the plate, then fasten securely the plate with the attachment steel nail.
3. Find the wall hole location A using a measuring tape
When the mounting plate is fixed side bar and lintel
Fix to side bar and lintel a mounting bar, Which is separately sold, and then fasten
the plate to the fixed mounting bar.
Refer to the previous article, "
position of wall hole.
2.Making a Hole on the Wall and Fitting the Piping Hole Cover
Make a hole of 70 mm in diameter,
slightly descending to outside the wall.
Install piping hole cover and seal it
off with putty after installation

3.Installation of the Indoor Unit

Drawing of pipe
[ Rear piping ]
Draw pipes and the drain hose, then fasten them with the adhesive tape
[ Left
Left-rear piping ]
In case of left side piping, cut away, with a nipper, the lid for left piping.
In case of left-rear piping, bend the pipes according to the piping direction to the mark of hole for left-rear
piping which is marked on heat insulation materials.
Indoor unit
Find the level position
When the mounting plate is first fixed ", for the
(Section of wall hole)
B=70mm
A=180mm
Indoor side
Wall hole
70mm
G
3
Outdoor side
Thickness
of wall
Piping hole pipe

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hsu-12lh13

Table of Contents