Advertisement
Quick Links
Programming instructions for KF935
For 'Superlift' branded motors:
Roller Doors
1. Remove the cover from the control box by lifting the tab at the bottom.
2. Press & release the 'Transmitter Coding Button' located next to LED on the
recessed circuit board. The LED will illuminate.
3. Press and release the desired button on the new remote. The LED on the control
box will extinguish.
4. Replace the cover on the control box.
Sectional/Panel lift Doors:
1. Located on the back of the motor, press and release the 'Learn' button. The LED
will illuminate.
2. Press and release the desired button on the new remote. The LED on the motor
will extinguish.
For 'Avanti' Branded motors:
1. (If the garage door is open) Close the door.
2. Open the light cover on the motor.
3. Press and release the red 'Learn' button.
4. Press the desired button twice; on the new remote.
5. Replace the light cover
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Map KF935
Summary of Contents for Map KF935
- Page 1 Programming instructions for KF935 For ‘Superlift’ branded motors: Roller Doors 1. Remove the cover from the control box by lifting the tab at the bottom. 2. Press & release the ‘Transmitter Coding Button’ located next to LED on the recessed circuit board. The LED will illuminate.
- Page 2 WARNING! This remote control contains a button/coin cell battery. It is a lithium button/coin cell battery. If swallowed or placed inside any part of the body, a lithium battery can cause severe or fatal injuries within 2 hours or less. The battery is hazardous and should be kept out of reach of children at all times whether new or used.
Need help?
Do you have a question about the KF935 and is the answer not in the manual?
Questions and answers