Advertisement
Programming instructions for KF373 & KF374
Key blade must be cut from key blade tip to remote head
Transponder requires programming with scan tool. Please contact your local
Mitsubishi dealer or workshop to program transponder in MAP part no: KF373 &
1. Insert key into the ignition (leave in the Lock position).
2. Insert OBD Programmer in to the vehicles OBD2 port located beneath the dash.
3. Press the hazard lights switch 6 times rapidly.
If performed correctly, the door locks will cycle. You are now in learn mode.
4. Press the Lock button on new remote 4 times. Door locks cycle when accepted.
5. Repeat step 4 for any other remotes including old remotes.
6. Remove OBD Programmer from the vehicles OBD port and remove the key from
the ignition to exit learn mode.
Key blade requires cutting by your local locksmith.
REMOTE PROGRAMMING PROCEDURE:
Blade
cutting
direction
KF373
KF374.
Blade
cutting
direction
KF374
Advertisement
Table of Contents
Related Manuals for Map KF373
Summary of Contents for Map KF373
- Page 1 Key blade requires cutting by your local locksmith. Key blade must be cut from key blade tip to remote head Transponder requires programming with scan tool. Please contact your local Mitsubishi dealer or workshop to program transponder in MAP part no: KF373 & KF374. REMOTE PROGRAMMING PROCEDURE: 1.
- Page 2 Warning! This remote contains a button/coin cell battery. If swallowed, a lithium battery can cause severe or fatal injuries within 2 hours. Keep batteries out of reach of children. If you think batteries may have been swallowed or placed inside any part of the body, seek medical attention immediately.
Need help?
Do you have a question about the KF373 and is the answer not in the manual?
Questions and answers