CONTENTS PAGE 2-3. Important safety information 4. Stroller overview / Inside the box 5. Assembly 6. Rear wheel installation & bumper bar installation 7. Folding the stroller 8. Backrest adjustment / Raincover fitting 9. Brake adjustment 10. Harness adjustment 11. Canopy & calf rest adjustment 12.
Page 3
IMPORTANT - READ CAREFULLY AND KEEP FOR FUTURE REFERENCE. Important Safety Information. This vehicle is intended for children from birth to a maximum of 22kg. The seat unit is suitable for one child only to the maximum weight stated above. It is important that any person intending to use this stroller understands the instructions.
Page 4
WARNING: Always use the seat in the most reclined position for new born babies to approx. 6 months. WARNING: Always use the crotch strap in combination with the waist belt. WARNING: Never leave the stroller without first engaging the parking device.
Page 5
Stroller Overview Easy one-hand fold Extendable canopy Detachable bumper bar 5-point harness Shopping basket Flip-flop friendly brake Inside the box Open the box and remove the stroller, rear wheels, bumper bar and raincover. 1. Box 2. Bumper bar 3. Rear wheels x 2 4.
Installation 1. Attach both front wheels by pushing up until you hear a click. 3. Push in 1 and 2. Attach the rear wheels by pushing pull in 2 to open in until you hear a click. the stroller. WARNING: Ensure wheels are fitted securely.
Page 7
Rear Wheel Installation / Removal Installation: Insert the rear wheel into the bracket and a ‘click’ sound will indicate that it is in place. Removal : Push in the button on the bottom of the wheel bracket, then pull the wheel outwards. Bumper Bar Installation Fitting: Attach the front bar by sliding into the catch until you hear...
Folding the stroller 1. Close the canopy 2. Using your thumb, hold the button on the bottom of the handle. Use the remaining fingers to press the button on the bottom of the handle, then release the handle. The stroller will fold. 3.
Backrest Adjustment 1. To sit upright: Pull up the lever and push the backrest upwards 2. To lie down: Pull up the lever and move the backrest downward. WARNING: Use in fully reclined position from birth to approx. 6 months old. WARNING: Always use the harness.
Brake Adjustment Step on the brake pad at the rear wheel bar to apply the brake. To release the brake, lift up the brake pad or push down on the highest part. Front Wheel Installation / Removal Attach both front wheels by pushing up until you hear a click.
Harness Adjustment Buckle up Place together and join magnetic parts, and place part with buttons on top. As below until you hear a click. Releasing the buckle Press in buttons and lift to release the 5-point magnetic buckle. Harness Shoulder height adjustment: Unfasten the harness shoulder straps so that the two short straps dangle from the seat backrest.
Page 12
Canopy & calf rest adjustment 1. Canopy adjustment: Pull the sun canopy forward to open it - unzip the canopy to extend it further and push it backward to retract. 2. Calf rest adjustment: Pull the lever underneath the calf rest to adjust its angle.
CARE AND MAINTENANCE • Regularly check screws, rivets, bolts and fastenings to ensure they are locked tight and secure. Replace any parts in an inferior condition. When using this product during the winter, by the sea or off road it is important to clean using fresh water and dry thoroughly.
SERVICING OF YOUR EGGZ STROLLER We recommend that this product is regularly maintained and is serviced by a BabyStyle authorised dealer at least every 12 months. Only replacement parts supplied or recommended by the manufacturer/distributor shall be used. DISCLAIMER...
WARRANTY TERMS • Chassis: 24 consecutive months. • Fabrics, accessories and PVC rain cover: 6 consecutive months. • The warranty only applies to the original purchaser and is non-trans- ferable. The warranty will be invalidated in the following circumstances: • The product has not been used for its intended purpose as described within the instruction manual.
Need help?
Do you have a question about the eggZ and is the answer not in the manual?
Questions and answers