Belkin F5U304 User Manual page 7

Installation
Important Note: The Hub must be connected to a USB 2.0-compliant host in order
to function in high-speed mode (480Mbps data rate). If the Hub is connected to a
USB 1.1-compliant host, it will operate only in low-speed or full-speed mode
(1.5Mbps/12Mbps).
3. Windows will now detect your Hub and install the required driver support. (The
Windows "Install New Hardware Wizard" may prompt you to provide your Windows
Installation CD to complete the driver installation process.)
Important Note: High-speed hub drivers are included with most USB 2.0 PCI
upgrade cards, and are preinstalled along with the PCI card drivers. If you purchased
an upgrade card prior to the release of high-speed hub support, please check with
your PCI card vendor for an updated USB 2.0 driver. The Belkin USB 2.0 driver
supports all competitive cards based on the NEC host controller with the exception
of Adaptec.
4. Plug the USB A connector of the USB device, or an additional hub, into any of the
downstream ports of the Hub.
Important Note: When moving a device from one port on the Hub to another, it may
be necessary to reinstall the USB drivers for that device.
Installation | 04