Table of Contents Introduction Features ............................1 Package Contents........................2 Technical Specifications......................2 Installation............................3 Information ............................5...
USB 2.0 (or high-speed) devices. This includes such peripherals as scanners, printers, mass-storage devices, and high-resolution cameras. The Hub is self-powered, which allows you to cascade devices with additional hubs, so that up to 127 USB devices may be connected to a single port.
Per-Port Voltage: DC +5V Per-Port Current: 500mA (max) (self-powered mode) Power Mode: Self-powered/bus-powered Operating Temperature: 5° C ~ 40° C Storage Temperature: -20° C ~ 60° C Enclosure: Power Supply: Output: DC 6V, 2.1A Plug Size: 3.5mm (outer) 1.0mm (center)
Important Note: Please do not connect any USB devices to the Hub until instructed to do so in step 4 of this installation procedure. 1. Plug the AC adapter into a wall outlet or surge protector. Plug the DC connector into the DC power jack found on the rear of the Hub.
Page 7
NEC host controller with the exception of Adaptec. 4. Plug the USB A connector of the USB device, or an additional hub, into any of the downstream ports of the Hub. Important Note: When moving a device from one port on the Hub to another, it may be necessary to reinstall the USB drivers for that device.
F5U304 to which this declaration relates: Complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
What is not covered by this warranty? All above warranties are null and void if the Belkin product is not provided to Belkin Corporation for inspection upon Belkin’s request at the sole expense of the purchaser, or if Belkin Corporation determines that the Belkin product has been improperly installed, altered in any way, or tampered with.
Page 10
The cost, if any, of shipping the equipment to and from such repair facility and of such estimate shall be borne solely by the purchaser. Damaged equipment must remain available for inspection until the claim is finalized.