Advertisement

Quick Links

OPERATING INSTRUCTIONS
EFFICIENT • WARM • FRIENDLY

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MK3 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Nectre Fireplaces MK3

  • Page 1 OPERATING INSTRUCTIONS EFFICIENT • WARM • FRIENDLY...
  • Page 2 Glen Dimplex Australia proudly supports the activities of Landcare Australia through its membership of the AHHA. NECTRE MK3 VERSION 1.0...
  • Page 3: Table Of Contents

    TABLE OF CONTENTS USER INSTRUCTIONS MAINTENANCE AND SERVICING Introduction ......... . Replacement of Fire Bricks .
  • Page 4: User Instructions

    USER INSTRUCTIONS WARNING: KEEP BATTERIES OUT OF REACH OF INTRODUCTION CHILDREN Before use of this appliance please read these instructions Swallowing may lead to serious injury in as little as 2 hours fully. or death, due to chemical burns and potential perforation WARNING: ANY MODIFICATION OF THE APPLIANCE of the oesophagus.
  • Page 5: Air Controls

    1.1. AIR CONTROLS 1.4. The Nectre Mk3 has two air controls for controlling the fire. The fan can be used to spread heat around the room quicker, as well as distribute heat into other rooms. It does Top air slide: This allows air to enter the firebox from above not have to be on if not required.
  • Page 6: Recommended Fuels

    RECOMMENDED FUELS RUNNING THE APPLIANCE Burn only seasoned hardwood timber with a moisture The heat output of the appliance is controlled by the top content of less than 20%. Newly cut wood should be air slide. allowed to dry/season for 12 to 18 months before use. 5.1.
  • Page 7: Burning Tips

    5.3. RELOAD WITH MORE WOOD 6.2. FLUE DRAUGHT Open air slide before opening door. The flue has two main functions: To safely remove smoke, gases and fumes from the Rake / break up any existing coals. appliance. Load the wood with the length orientated front to To provide a sufficient amount of draught (suction) back.
  • Page 8: Cleaning Paintwork And Glass

    CLEANING PAINTWORK AND GLASS TROUBLESHOOTING TIPS The heater, when cool, can be cleaned with a damp cloth. 11.1. GLASS IN DOOR BLACKENING Over the years, the black paint will fade and can be This can have several possible causes: touched up with Stove Bright metallic black paint. ●...
  • Page 9: Maintenance And Servicing

    REPLACEMENT OF BAFFLE PLATES thermal mass and to guarantee the longevity of the steel The Nectre Mk3 is fitted with two thick steel baffle plates firebox. Over time the firebricks may become cracked and which help to retain the heat in the firebox by lengthening crumble away.
  • Page 10: Fitting New Door Glass

    FITTING NEW DOOR GLASS FITTING A NEW DOOR SEAL This task may be easier with the door removed from the This task may be easier with the door removed from the appliance and laid horizontally on a work-bench. appliance and laid horizontally on a work-bench. To replace the door glass: Remove any old seal from the door.
  • Page 11: Replacement Of Ash Plate

    REPLACEMENT OF ASH PLATE RECEIVER REPLACEMENT The ash plate acts to protect the front of the firebox below Over the life of the heater, the fan receiver may fail. If this the door opening from the hot coal bed and fire. occurs, it will need to be replaced.
  • Page 12: Fan Replacement

    FAN REPLACEMENT Unplug the power lead before proceeding. To change/remove the fan assembly from underneath the unit. Remove the fan cover. The M12 button screw securing this can be removed with an 8mm hex key. Lift the fan assembly over the shelf lip. Disconnect the fan from the power cable, and remove fan from heater.
  • Page 13: Replacement Spare Parts List

    REPLACEMENT SPARE PARTS LIST PART NO. PART DETAIL NFBMK3S Fire Brick Set 11 @ 230 x 115 x 38mm N108-020 Brick Retainer 560mm x 420mm N900-048 Baffle Plate Upper 400 x 160 x 5mm steel N104-036 Baffle Plate Lower 500 x 300 x 12mm steel N900-106 Door Seal 1610mm x 13mm round...
  • Page 14: Warranty

    WARRANTY Consumers may have additional rights under the Australian Trade Practices Act 1974 including the Warranty is provided in Australia by Glen Dimplex Australia Australian Consumer Law or the Consumer Guarantees Pty Ltd and in New Zealand by Glen Dimplex New Zealand Act 1993 New Zealand.
  • Page 15 or modifications by persons not authorised by Glen Dimplex, use of parts not supplied by Glen Dimplex, or damage or other events which have occurred since the product left the control of Glen Dimplex. ● Removal or transportation of such product or part (and any repaired or replacement product or part) to and from the authorized dealer’s or service agents place of business.
  • Page 16 Glen Dimplex Australia Pty Ltd 8 Lakeview Drive, Scoresby Victoria 3179 Australia T: 1300 554 155 General & Sales Enquiries: flame.care@glendimplex.com.au Technical Service: flame.support@glendimplex.com.au www.glendimplex.com.au...

Table of Contents