Advertisement
How to use this manual?
The game controller is compatible with PC, PlayStation®2 and PlayStation®.
For PC users, please refer to section A of "Installation for PC system".
For PlayStation®2 and PlayStation®, refer to section B of "Installation for PlayStation®2 and
PlayStation®".
A. Installation for PC system
1. Install four AA batteries in the game pad
2. Make sure you turn your computer on.
3. Insert the driver disc into the CD-ROM drive,
and the setup program will start automatically. If
not, start the setup program manually by
selecting Start/Run and type in "E:\setup"
(Where "E:" represents the location of the
CD-ROM drive), then press the Enter key.
(If you are using Windows 98, just follow the
instructions on the screen to finish the installation)
4. Please follow the instructions on the screen to
finish the driver installation. (Some operating
systems will install the DirectX program
automatically
first,
so
instructions on the screen to finish the program
installation.)
5. After the software installation is completed, you
can plug the USB connector of the cable to the
port on the receiver and another USB connector
to the USB port on your computer.
6. Press and hold the Connection/Vibration button of the game pad until the MODE LED
flashes in green, then press the button of the receiver to connect with each other.
7. Click Start / Settings / Control Panel and double click on the "Game Controllers" or
"Gaming Options" icon.
8. In the "Game Controllers" or "Gaming Options" screen, you can calibrate and test your
game controller before you play any game.
9. When you finish the calibration and test, you can now play any game.
just
follow
the
1
English
Advertisement
Table of Contents
Related Manuals for Genius WG-12PS
Summary of Contents for Genius WG-12PS
- Page 1 6. Press and hold the Connection/Vibration button of the game pad until the MODE LED flashes in green, then press the button of the receiver to connect with each other. 7. Click Start / Settings / Control Panel and double click on the “Game Controllers” or “Gaming Options” icon.
- Page 2 English Connect Game Pad with Receiver 1. Press and hold the Connection/Vibration button of the game pad until the LED flashes. 2. Press the button of the receiver to connect with each other. Condition On line Off line Connecting Flashes B.
- Page 3 For optimal performance, place the receiver at least 8 inches (about 20 cm) away from other electrical devices, such as the computer, monitor, and etc. 4. If you feel this game device does not move as smooth as usual, then the batteries have lost their charge, so please replace them.
- Page 4 Red Light 3. Power Saving Mode: When you stop operating this game pad for some time (shown below), it enters a “Power Saving” status to prevent battery usage. You can wake up it by pressing one of the key-buttons like Vibration/Connection, Mode, Select and Start.
Need help?
Do you have a question about the WG-12PS and is the answer not in the manual?
Questions and answers