Wenglor TPL LBO Series Operating Instructions Manual

INTRODUCTION
This Technical User Guide contains warnings and guidance for correct and safe operation of the product.
These instructions must be followed at all times. wenglorTPL will not be held responsible for problems caused
by using the product contrary to these instructions and the Warranty will be deemed invalid.
UNPACKING
This product is packed at the factory using suitable materials for safe transport. To open the package, do not use
any cutting blade to avoid damaging the product(s). Please use the delivered accessories if needed. (Do not use any
other products or equivalents to replace the delivered accessories).
In the event of damage occurring during shipping, it must be reported to the carrier at time of delivery (including
noting the damage in writing on the delivery documents). It is also your responsibility to notify wenglorTPL in wri-
ting of the damage within 24 hours of receipt of the package. If these instructions are not followed, wenglorTPL
reserves the right not to accept requests for return and exchange of damaged products.
RISK CLASS
The applicable Standard EN-62471 classifies LED Lighting into 4 classes according to their degree of hazard severity.
The table below summarises the risks associated with our standard products.
Color
White WHI, Red 630 nm
IR 850 nm
wenglorTPL can provide guidance notes to minimise photo-biological risks, including the nominal minimum
operating distance. Please contact wenglorTPL through your usual representative for this information.
BEWARE to the infrared light, invisible to the eyes.
To know if the light is on, please refer to the LED indicators.
LBOxxxx
OPERATING INSTRUCTIONS
Class
0
1
Risk
In all cases, wenglorTPL recommends
the use of protection glasses.
none
low