Global Cache Flex Link G-IR-E Quick Start Manual

Quick Start Guide
Emitter (G-IR-E), Blaster (FLC-BL), 3 Emitters (FLC-3E), 2
Emitters/1Blaster (FLC-2E1B), Tri-port (FLC-T3)
Getting Started
Once the Flex is connected to the network (see
Flex Quick Starts), plug the Flex Link IR cable
into the Flex Link Port.
To configure Flex Link IR cables, right-click on
On the Flex Link Cable page, select Infrared
in the dropdown menu, then select one of the
four options corresponding to the Flex Link IR
cable plugged into the Flex Link Port.
(1) Single Emitter (G-IR-E)
Configures the Flex to work with a single emit-
ter (G-IR-E) cable plugged into the Flex Link
Port. Emitters are short-range IR transmitters
designed for placement directly over the IR
receiver of the controlled device with a range
of roughly 1 inch (2.5 cm).
(2) Single Blaster (FLC-BL)
Configures the Flex to work with a single IR
Blaster (FLC-BL) cable plugged into the
Flex Link IR Cables
the unit entry in iHelp
and select Config-
ure, or enter the Flex
unit's IP address into
a web browser to
access the Flex Con-
figuration page.