Global Cache Flex Link Series Quick Start

Flex Link Serial Cable

Quick Start

Global Caché

is lessening our carbon

footprint by reducing our paper

output. For complete documentation

and tutorials, visit:

www.globalcache.com/docs

Getting Started.

Once the iTach Flex is

connected to the network by either an Eth-

ernet cable or WiFi, plug the Flex Link Se-

rial cable into the Flex Link Port.

To configure Serial cable fuctionality, right

click on the unit entry in iHelp* and click

configure. A web browser will present the

web configuration pages of the Flex. To

access the set up pages manually, type in

the unit's IP address. Flex units in de-

fault will reside at the default address of

http://192.168.1.70. On the "Flex Link

Port Configuration" page, select "Flex Link

Serial Cable" to configure the settings as de-

sired.

Flex Link Serial cables can be set to either

standard (straight through) or crossover

(null modem) modes by changing the

Quickstart_FLCserial_1up_062713.indd 1

7/1/2013 12:56:09 PM

Table of Contents

Do you have a question about the Flex Link Series and is the answer not in the manual?

Page 1 Flex Link Serial Cable Quick Start Global Caché is lessening our carbon footprint by reducing our paper output. For complete documentation and tutorials, visit: www.globalcache.com/docs Getting Started. Once the iTach Flex is connected to the network by either an Eth- ernet cable or WiFi, plug the Flex Link Se- rial cable into the Flex Link Port.
Page 2 “Crossover” setting. The default setting of False puts the Serial cable in standard mode. To change to crossover mode, select True, then select Save Changes to apply the new settings. Disconnecting the Serial cable from the Flex Link Port will reset all open TCP sockets and reinitialize the Serial cable.