Download Print this page

Global Cache Flex Link Quick Start

Tri-port cable

Hide thumbs Also See for Flex Link:

Flex Link Tri-Port Cable

Quick Start

Global Caché

is lessening our carbon

footprint by reducing our paper

output. For complete documentation

and tutorials, visit:

www.globalcache.com/docs

Getting Started.

Once the iTach Flex is

connected to the network by either an Eth-

ernet cable or WiFi, plug the Flex Link Tri-

port cable into the Flex Link Port.

To configure the Tri-port IR fuctional-

ity, right click on the unit entry in iHelp*

and click configure. A web browser will

present the web configuration pages of the

Flex. To access the set up pages manually,

type in the unit's IP address. Flex units in

default will reside at the default address of

http://192.168.1.70. On the "Flex Link

Port Configuration" page, select "Flex Link

Tri-port Cable" to configure the settings as

desired.

Quickstart_FLCtriport_1up_062713.indd 1

7/1/2013 1:31:56 PM

Table of Contents

Do you have a question about the Flex Link and is the answer not in the manual?

Page 1 Getting Started. Once the iTach Flex is connected to the network by either an Eth- ernet cable or WiFi, plug the Flex Link Tri- port cable into the Flex Link Port. To configure the Tri-port IR fuctional- ity, right click on the unit entry in iHelp* and click configure.
Page 2 The 3 IR ports on the Tri-port cable can be used as 3 IR emitters or 2 emitters and 1 Flex Link Blaster cable (on IR3).To use IR3 with a Flex Link Blaster cable, change “Blaster Connected on IR3” from False to True. Then select Save Changes to apply the new settings.