Global Cache FLC-BL Quick Start Manual

Quick Start Guide
Flex Link Blaster Cable (FLC-BL)
Getting Started
Once the Flex is connected to the network (see
Flex Quick Starts), plug the Flex Link Blaster
cable (FLC-BL) into the Flex Link Port.
To configure the FLC-BL, right-click on the unit
To access the set-
tings, select the
Flex Link Cable
tab. Then select
Infrared from the
Change Flex Link
cable field, then select Single Blaster (FLC-
BL). If using a Flex Link Tri-Port cable (FLC-T3),
select 2 Emitter, 1 Blaster (FLC-2E1B) and
plug the FLC-BL into IR port 3 of the FLC-T3
cable.
Select Save Changes to apply the new set-
tings.
Flex Link Cable
entry in iHelp and
select Configure, or
enter the Flex unit's
IP address into a web
browser to access the
Flex Configuration
page.