Advertisement
NOTE:
When you set gamut alarm to
either "Destination" or
"Simulation", the puzzle
pieces in the sockets are
black.
To set gamut alarm:
NOTE:
To use gamut alarm in the
Simulation mode, be sure
that you select the "Use
simulation" check box.
1.
Pull down the Gamut alarm list,
and select either:
•
"Simulation" to determine if the colors of the source transform are
out of the gamut of the simulation device
or
•
"Destination" to determine if the colors of the simulation or source
device are out of the gamut of the destination device.
2.
Create your color connector file.
Sources."
When you print the file, any out-of-gamut areas are printed
in black.
3.
To adjust the color representation in any out-of-gamut areas,
"Setting Rendering Intents."
CONTENTS
Refer to "Color Managing Multiple
INDEX
SEARCH
Operator's Guide
Printing Guide
Color Management
Calibration
Network
Interface Guide
Color Management
Options
Using Color
Connector
Menus and Dialog
Boxes
refer to
HELP
Advertisement
