For Long Operating Life - Kodak 8500 - USER'S GUIDE 240V User Manual

FOR LONG OPERATING LIFE

UNSUITABLE MATERIALS FOR THE PRINTER
Paint coat flaking and plastic deformation are likely to occur if the unit is wiped with chemical
dusters, benzine, thinner or any other solvent, if rubber or PVC items are left in contact with the
unit for a extended period, or if the unit is sprayed with insecticide.
CARE OF THE CABINET
Unplug and clean with a soft cloth slightly moistened with a mild soap and water solution. Allow
to dry completely before operating. Never use petroleum base solutions or abrasive cleaners.
HEAD ABRASION
The thermal print head, like a video head, wears out. When it is worn, it becomes hard to print
out fine details of the picture. Then it is necessary to replace the thermal head. Consult your
dealer about having the head replaced.
CONNECTING DEVICES
Read thoroughly the Safety Notices, Cautions and "Operating Precautions" of the instruction
booklets for the other devices connected with the unit.
CAUTION ON RELOCATING
When transporting this unit, make sure it is not likely to be subjected to impacts. They can be a
primary cause for damage. Before moving the unit, make sure to disconnect the power cord
from the power outlet, and the cables from the connected devices. Also make sure to remove the
paper tray.
CONTENTS PRINTER DRIVER GUIDE SEARCH HELP
Introduction
Setting up the 8500
Printer
Operating the 8500
Printer
Troubleshooting
Site Specifications
Accessories and
Supplies