Watchguard AP325 Hardware Manual page 7

USB Port
The USB port is currently not in use.
Reset Button
Resets the WatchGuard AP to factory-default settings. You must use a paper clip or other small object
to press the reset button through the small hole on the device.
To reset the AP to factory-default settings, while the AP is powered on, press and hold the reset
button for up to 10 seconds until all LEDs go off to indicate that the AP has rebooted.
If you press the reset button while the AP is not powered on or is booting, the reset button will have
no effect.
Hardware Guide
Hardware Specifications
5