ASROCK P4TWINS-HDTV User Manual page 33

IDE Device Configuration
You may set the IDE configuration for the device that you specify. We will
use the "Primary IDE Master" as the example in the following instruction,
which can be applied to the configurations of "Primary IDE Slave", "Sec-
ondary IDE Master", and "Secondary IDE Slave" as well.
IDE Device Configuration
You may set the IDE configuration for the device that you specify. We will
use the "Primary IDE Master" as the example in the following instruction.
BIOS SETUP UTILITY
Advanced
Primary IDE Master
Device :Hard Disk
Vendor :ST340014A
Size :40.0 GB
LBA Mode :Supported
:16Sectors
Block Mode
PIO Mode :4
:MultiWord DMA-2
Async DMA
Ultra DMA :Ultra DMA-5
:Supported
S.M.A.R.T.
Type [Auto]
[Auto]
LBA/Large Mode
[Auto]
Block (Multi-Sector Transfer)
[Auto]
PIO Mode
[Auto]
DMA Mode
[Disabled]
S . M . A . R . T .
[Enabled]
32Bit Data Transfer
v02.54 (C) Copyright 1985-2005, American Megatrends, Inc.
TYPE
Use this item to configure the type of the IDE device that you specify.
Configuration options: [Not Installed], [Auto], [CD/DVD], and [ARMD].
[Not Installed]: Select [Not Installed] to disable the use of IDE device.
[Auto]: Select [Auto] to automatically detect the hard disk drive.
After selecting the hard disk information into BIOS, use a disk
utility, such as FDISK, to partition and format the new IDE hard
disk drives. This is necessary so that you can write or read
data from the hard disk. Make sure to set the partition of the
Primary IDE hard disk drives to active.
[CD/DVD]: This is used for IDE CD/DVD drives.
[ARMD]: This is used for IDE ARMD (ATAPI Removable Media Device),
such as MO.
LBA/Large Mode
Use this item to select the LBA/Large mode for a hard disk > 512 MB under
DOS and Windows; for Netware and UNIX user, select [Disabled] to
disable the LBA/Large mode.
Select the type
of device connected
to the system.
Select Screen
Select Item
+- Change Option
F1 General Help
F9 Load Defaults
F10 Save and Exit
ESC Exit
3 3 3 3 3 3
3 3 3 3