Connectors - ASROCK P4I45E R3.0 User Manual

2.8 Connectors

Connectors are NOT jumpers. DO NOT place jumper caps over
these connectors.
Connector
FDD connector
(33-pin FLOPPY1)
(see p.9 item 12)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Primary IDE connector (Blue)
(39-pin IDE1, see p.9 item 8)
PIN1
connect the blue end
to the motherboard
Note: If you use only one IDE device on this motherboard, please set the IDE
device as "Master". Please refer to the instruction of your IDE device vendor
for the details. Besides, to optimize compatibility and performance, please
connect your hard disk drive to the primary IDE connector (IDE1, blue) and
CD-ROM to the secondary IDE connector (IDE2, black).
USB 2.0 Header
(9-pin USB45)
(see p.9 item 16)
Infrared module connector
(5-pin IR1)
(see p.9 item 17)
Figure
FLOPPY1
Pin1
IDE1
80-conductor ATA 66/100 cable
USB_PWR
P-5
1
P-4
USB_PWR
IRTX
1
IRRX
Secondary IDE connector (Black)
(39-pin IDE2, see p.9 item 7)
IDE2
PIN1
ASRock I/O
P+5
default USB 2.0 ports on the rear
GND
DUMMY
panel. If the rear USB ports are
not sufficient, this header is
GND
available to support 2 additional
P+4
USB 2.0 ports.
This connector supports an
+5V
DUMMY
optional wireless transmitting
and receiving infrared module.
GND
Description
the red-striped side to Pin1
connect the black end
to the IDE devices
TM
provides you 4