HOMCOM VC-6003 Manual page 5

Install
Mounting the host
1. The host mounting base is optional. You can decide whether to install it based on your
specific needs.
2. For installation, choose a cool and dry location with a nearby power supply. Avoid
placing the support in areas prone to humidity, like the kitchen, or direct sunlight.
3. Use appropriate wall mounting hardware to securely install the base. Ensure there are
no pipes (gas, water or ventilation), cables, wires or sewer lines directly behind the
installation area.
4. It is recommended to seek the assistance of professional personnel for equipment
installation. When necessary, use protective clothing, goggles and other safety gear.
5. Using an electric drill, start by drilling an 8mm diameter hole approximately 30mm deep
in the wall. Then, insert an expansion tube into the hole and secure the host mounting
base to the wall using screws.
Screw Expansion pipe
Recommended installation height: 1.06m above
the ground, along the lower edge of the support.
5