Oc Tweaker Screen - ASROCK M3N78D - V1.0 User Manual

3.3 OC T 3.3 3.3 OC Tweak OC T OC T weaker Screen weak weak er Screen er Screen er Screen
3.3 3.3 OC T weak er Screen
In the OC Tweaker screen, you can set up overclocking features.
Main OC Tweaker Advanced
CPU Configuration
Overclock Mode
CPU Frequency (MHz)
PCIE Frequency (MHz)
CPU/LDT Spread Spectrum
SATA Spread Spectrum
Boot Failure Guard
NVIDIA Core Calibration
CPU Active Core Control
Processor Maximum Frequency
North Bridge Maximum Frequency
Processor Maximum Voltage
Multiplier/Voltage Change
HT Bus Speed
HT Bus Width
CPU Thermal Throttle
v02.54 (C) Copyright 1985-2005, American Megatrends, Inc.
CPU Configuration
Overclock Mode
Use this to select Overclock Mode. The default value is [Auto]. Configura-
tion options: [Auto], [CPU, PCIE, Sync.], [CPU, PCIE, Async.] and [Optimized].
CPU Frequency (MHz)
Use this option to adjust CPU frequency.
PCIE Frequency (MHz)
Use this option to adjust PCIE frequency.
CPU/LDT Spread Spectrum
This feature will be set to [Enabled] as default. Configuration options:
[Disabled] and [Enabled].
SATA Spread Spectrum
This feature will be set to [Enabled] as default. Configuration options:
[Disabled] and [Enabled].
Boot Failure Guard
Enable or disable the feature of Boot Failure Guard.
NVIDIA Core Calibration
Setting this item to [All Cores] or [Per Core] will enhance the overclocking
ability of the processor. Configuration options: [Disabled], [Auto], [All Cores]
and [Per Core]. The default value is [Disabled].
CPU Active Core Control
This allows you to adjust CPU Active Core Control feature. The configura-
tion options depend on the CPU core you adopt. The default value is [All
Cores].
BIOS SETUP UTILITY
H/W Monitor Boot Security
Overclocking may cause
damage to your CPU and
[Auto]
motherboard.
[200]
It should be done at
[100]
your own risk and
[Enabled]
expense.
[Enabled]
[Enabled]
[Disabled]
[All Cores]
x15.0 3000 MHZ
Select Screen
x10.0 20 00 MHz
Select Item
1.3000 V
Enter Go to Sub Screen
[Auto]
F1 General Help
[Auto]
F9 Load Defaults
[Auto]
F10 Save and Exit
[Enabled]
ESC Exit
3 6 3 6 3 6 3 6 3 6
Exit