ASROCK M3N78D - V1.0 User Manual page 37

Processor Maximum Frequency
It will display Processor Maximum Frequency for reference.
North Bridge Maximum Frequency
It will display North Bridge Maximum Frequency for reference.
Processor Maximum Voltage
It will display Processor Maximum Voltage for reference.
Multiplier/Voltage Change
This item is set to [Auto] by default. If it is set to [Manual], you may adjust the
value of Processor Frequency and Processor Voltage. However, it is
recommended to keep the default value for system stability.
BIOS SETUP UTILITY
Main OC Tweaker Advanced
CPU Configuration
Overclock Mode
CPU Frequency (MHz)
PCIE Frequency (MHz)
CPU/LDT Spread Spectrum
SATA Spread Spectrum
Boot Failure Guard
NVIDIA Core Calibration
CPU Active Core Control
Processor Maximum Frequency
North Bridge Maximum Frequency
Processor Maximum Voltage
Multiplier/Voltage Change
CPU Frequency Multiplier
CPU Voltage
NB Frequency Multiplier
NB Voltage
v02.54 (C) Copyright 1985-2005, American Megatrends, Inc.
CPU Frequency Multiplier
For safety and system stability, it is not recommended to adjust the value of
this item.
CPU Voltage
It allows you to adjust the value of CPU voltage. However, for safety and
system stability, it is not recommended to adjust the value of this item.
NB Frequency Multiplier
For safety and system stability, it is not recommended to adjust the value of
this item.
NB Voltage
It allows you to adjust the value of NB voltage. However, for safety and
system stability, it is not recommended to adjust the value of this item.
HT Bus Speed
This feature allows you selecting Hyper-Transport bus speed. Configura-
tion options: [Auto], [x1 200 MHz] to [x10 2000 MHz].
HT Bus Width
This feature allows you selecting Hyper-Transport bus width. Configura-
tion options: [Auto], [8 Bit] and [16 Bit].
H/W Monitor Boot Security Exit
Overclocking may cause
damage to your CPU and
[Auto]
motherboard.
[200]
It should be done at
[100]
your own risk and
[Enabled]
expense.
[Enabled]
[Enabled]
[Disabled]
[All Cores]
x15.0 3000 MHZ
Select Screen
x10.0 20 00 MHz
Select Item
1.3000 V
Enter Go to Sub Screen
[Manual]
F1 General Help
[x15.0 3000 MHZ]
F9 Load Defaults
[1.3000 V]
F10 Save and Exit
[x10.0 2000 MHz]
ESC Exit
[1.1000 V]
3 7 3 7 3 7 3 7 3 7