ASROCK K8UPGRADE-VM800 User Manual page 28

AGP Mode
The default value of this feature is set to [Auto]. If you install an 8X-AGP
card on this motherboard, you may select [Auto], [8X] or [4X] as the AGP
mode. If the installed AGP card is a 4X-AGP card, then you may set the AGP
mode as [Auto], [4X], [2X], or [1X].
AGP Fast Write
This allows you to enable or disable the feature of AGP fast write protocol
support.
IDE Driving Strength
Select [Lowest], [Low], [Normal], or [Highest] for IDE driving strength.
PCI Delay Transaction
Enable PCI Delay Transaction feature will free the PCI Bus when the CPU is
accessing 8-bit ISA cards. Disable this feature when using ISA cards that
are not PCI 2.1 compliant.
OnBoard LAN
This allows you to enable or disable the onboard LAN feature.
OnBoard AC'97 Audio
Select [Auto], [Enabled] or [Disabled] for the onboard AC'97 Audio feature.
OnBoard MC'97 Modem
Select [Auto], [Enabled] or [Disabled] for the onboard MC'97 Modem feature.
HT Width
You may set the HyperTransport width as [8 bit], [16 bit] or [Auto]. The
default value is [Auto].
HT Speed
You may set the HyperTransport speed as [Auto], [200 MHz], [400 MHz],
[600 MHz], or [800 MHz]. The default value is [Auto].
2 8 2 8 2 8 2 8 2 8