ASROCK K7S41 User Manual page 27

OnBoard FDC: Use this to enable or disable floppy drive controller.
OnBoard Serial Port: Use this to set addresses for the onboard serial ports or
disable serial ports. Configuration options: [Auto], [Disabled], [3F8 / IRQ4 /
COM1], [2F8 / IRQ3 / COM2], [3E8 / IRQ4 / COM3], [2E8 / IRQ3 / COM4].
OnBoard Infrared Port: You may select [Enabled] or [Disabled] for this
onboard infrared port feature.
OnBoard Parallel Port: Select Parallel Port address or disable Parallel Port.
Configuration options: [Auto], [Disabled], [378], [278].
Parallel Port Mode: Set the operation mode of the parallel port. The
default value is [ECP+EPP]. If this option is set to [ECP+EPP], it will
show the EPP version in the following item, "EPP Version".
OnBoard Midi Port: Select address for Midi Port or disable Midi Port.
Configuration options: [Disabled], [330], and [300].
Midi IRQ Select: Use this to select Midi IRQ.
OnBoard Game Port: Select address for Game Port or disable Game Port.
Configuration options: [Disabled], [200], [208].
OnBoard IDE: You may enable either the primary IDE channel or the secondary
IDE channel. Or you may enable both the primary and the secondary IDE
channels by selecting [Both]. Set to [Disabled] will disable the both.
Configuration options: [Disabled], [Primary], [Secondary], [Both].
OnBoard LAN: This allows you to enable or disable the onboard LAN feature.
OnBoard AC'97 Audio: Select [Disabled], [Auto] or [Enabled] for the onboard
AC'97 Audio feature.
OnBoard MC'97 Modem: Select [Disabled], [Auto] or [Enabled] for the
onboard MC'97 Modem feature.
System Hardware Monitor: You may check the status of the hardware on your
system. It allows you to monitor the parameters for CPU temperature, Mother-
board temperature, CPU fan speed, and critical voltage.
Advanced
System Hardware Monitor
CPU Temperature
M / B Temperature
CPU FAN Speed
Chassis FAN Speed
Vcore
+ 3.30V
+ 5.00V
+ 12.00V
F1:Help
Esc:Previous Menu
AMIBIOS SETUP UTILITY - VERSION 3.31a
35 C / 95 F
27 C / 82 F
3110 RPM
N/A
1.72 V
3.31 V
4.97 V
12.16 V
:Select Item
+/-:Change Values
Enter:Select
[ Setup Help ]
F9:Setup Defaults
F10:Save & Exit
Sub-Menu