Connectors - ASROCK K7S41 User Manual

For example, "Athlon XP 2000+" is an 1666MHz CPU: 12.5 (Multiplier) X 133MHz (External frequency) = 1666MHz
FID jumpers setting:
The jumper caps are not provided by ASRock. Please understand that ASRock
does not guarantee and support the adjustment of multiplier. These jumpers
setting may not apply to all multiplier-locked or even some unlocked AMD
CPU. Frequencies other than the recommended CPU bus frequencies may
cause the instability of the system or damage the CPU.

2.6 Connectors

Connectors are NOT jumpers. DO NOT place jumper caps over these
connectors. Placing jumper caps over the connectors will cause perma-
nent damage of the motherboard!
Connector
FDD Connector
(33-pin FLOPPY1)
(see p.7/p.8 No. 17)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Primary IDE Connector (Blue)
(39-pin IDE1, see p.7/p.8 No. 8)
IDE1
PIN1
connect the blue end
to the motherboard
Note: If you use only one IDE device on this motherboard, please set the IDE
device as "Master". Please refer to the instruction of your IDE device vendor
for the details. Besides, to optimize compatibility and performance, please
connect your hard disk drive to the primary IDE connector (IDE1, blue) and
CD-ROM to the secondary IDE connector (IDE2, black).
1
FID0
1
FID1
1
FID2
1
FID3
1
FID4
Figure
FLOPPY1
Pin1
Secondary IDE Connector (Black)
(39-pin IDE2, see p.7/p.8 No. 7)
80-conductor, ATA 66/100/133 cable
Description
the red-striped side to Pin1
IDE2
PIN1
connect the black end
to the IDE devices