Vor dem ersten Gebrauch Bitte lesen Sie vor dem ersten Gebrauch die Bedienungsanleitung und die Sicherheitshinweise aufmerksam durch. Bewahren Sie die Bedienungsanleitung zusammen mit dem Gerät für den späteren Gebrauch auf . Sollten andere Personen dieses Gerät nutzen, so stellen Sie ihnen diese Anleitung zur Verfügung .
Zeichenerklärung Die folgenden Symbole werden in dieser Bedienungs- anleitung, auf dem Rollei LUMIS I-Light RGB oder auf der Verpackung verwendet . Mit diesem Symbol gekennzeichnete Produkte erfüllen alle maßgeblichen Gemeinschaftsvor- schriften des Europäischen Wirtschaftsraumes . Mit diesem Zeichen gekennzeichnete Produkte...
Sicherheitshinweise – Schließen Sie das Produkt nur dann an, wenn die Netzspannung des USB-Eingangs oder USB-Netzteils mit den Angaben auf dem Typenschild auf der Rück- seite des Produkts übereinstimmt . – Verwenden Sie das Produkt nicht, wenn es sichtbar beschädigt ist oder wenn das USB-C-Kabel defekt ist . –...
Page 7
Sicherheitshinweise – Schützen Sie das Produkt vor Feuchtigkeit . Berühren Sie es nicht mit nassen/feuchten Händen und tauchen Sie es nicht unter Wasser . – Dieses Produkt ist nicht wasserdicht! Benutzen Sie dieses Produkt nicht im Regen oder in nassen Um- gebungen .
Page 8
Sicherheitshinweise – Richten Sie das Produkt nicht auf Auto-, Bus-, Fahrrad-, Motorradfahrer oder Zugführer während der Fahrt . Der Fahrer kann geblendet werden und so einen Unfall verursachen . Dieses gilt auch für nicht aufgeführte Personen oder Gruppen, wenn durch eine mögliche Blendung ein Unfall verursacht werden könnte .
Vorsichtsmaßnahmen – Laden Sie den Akku vollständig auf und entfernen Sie anschließend das USB-C-Kabel . – Wurde das Produkt für einen längeren Zeitraum nicht mehr genutzt, laden Sie den Akku vor der erneuten Nutzung . – Um die Akkulaufzeit zu verlängern, sollten Sie den Akku mindestens alle drei Monate laden .
Produktübersicht Magnete USB-C-Eingang Auswahltaste Einstelltasten Ein-/Aus- / Modustaste Display (OLED) ¼“-Gewinde *Beachten Sie, dass die Haftung der Magneten von der Oberflächenstruktur abhängig ist .
Bedienung Ein-/Aus-/Modustaste [5] – Über die Ein-/Aus-/Modustaste [5] können Sie über langes Drücken das Rollei LUMIS I-Light RGB an- oder ausschalten . Mit einem kurzen Drücken können Sie die Modi wechseln (CCT-/Farbtemperatur-Modus, RGB-Mo- dus oder Effektmodus) . CCT-Modus / Farbtemperatur-Modus...
Page 13
Bedienung RGB-Modus Akkuladestand RGB-Farbwert Sättigung Helligkeit – Drücken Sie im RGB-Modus die Auswahltaste [3], um zwischen den Einstellungen des RGB-Farbwerts, der Sättigung und der Helligkeit zu wechseln . Über die Einstelltasten [4] können die Werte angepasst werden . wird der Wert erhöht, mit verringert .
Page 14
Bedienung Effektmodus Akkuladestand Effekt Helligkeit – Drücken Sie im Effektmodus die Auswahltaste [3], um zwischen den Einstellungen der 20 Effekte und der Helligkeit zu wechseln . Über die Einstelltasten [4] kön- nen die Werte angepasst werden . Mit wird der Wert erhöht, mit verringert oder der Effekt gewechselt .
– Verwenden Sie zum Laden des Rollei LUMIS I-Light RGB Netzteile mit einem Ausgang von DC 5,0 V 2,0 A . Das Rollei LUMIS I-Light RGB unterstützt das Laden per Quick Charger und USB-Power-Delivery (USB-PD) bis zur oben genannten Spannung .
DC 5,0 V 2,0 A Anschlüsse ¼“-Gewinde Maße (LxBxH) 20 x 4 x 3,5 cm Gewicht 160 g Lieferumfang Rollei LUMIS I-Light RGB,Mini- Stativ, USB-C-Kabel (1 m) Änderungen von Design und technischen Daten bleiben vorbehalten und bedürfen keiner Ankündigung . DEUTSCH...
Warnhinweise für Akkus – Demontieren, schlagen oder durchstechen Sie den Akku nicht, achten Sie darauf, den Akku nicht kurzzu- schließen . – Setzen Sie den Akku keinen Orten mit hohen Tempera- turen aus . Verwenden Sie den Akku nicht weiter, falls er ausläuft oder sich ausdehnt .
Entsorgung Entsorgen Sie die Verpackung sorten- rein. Nutzen Sie dafür die örtlichen Möglich- keiten zum Sammeln von Papier, Pappe und leichten Verpackungen . (Anwendbar in der Europäischen Union und anderen europäischen Staaten mit Systemen zur getrennten Sammlung von Wertstoffen .) Geräte, die mit diesem Symbol ge- kennzeichnet sind, dürfen nicht mit dem Hausmüll entsorgt werden! Sie...
Konformität Hiermit erklärt die Rollei GmbH & Co . KG, dass dieses Gerät „Rollei LUMIS I-Light RGB“ den folgenden Richt- linien entspricht: 011/65/EU RoHS-Richtlinie 2014/30/EU EMV-Richtlinie Der vollständige Text der EU-Konformitätserklärung ist unter der folgenden Internetadresse verfügbar: www .rollei .de/egk/lumisilight Rollei GmbH &...
Before the First Use Please read the operating instructions and the safety instructions carefully before using the device for the first time. Keep the operating instructions together with the device for future use . If you pass on the device to a third party, this manual is part of the device and must be supplied with the device .
Explanation of Symbols The following symbols are used in this manual, on the Rollei LUMIS I-Light RGB, the power supply unit or on the packaging . Products marked with this symbol comply with all relevant community regulations of the European Economic Area .
Safety Instructions – Only connect the product if the mains voltage of the USB input or USB power supply corresponds to the information on the type plate on the back of the product . – Do not use the product if it is visibly damaged or if the USB-C cable is defective .
Page 23
Safety Instructions – Do not open, damage, short circuit, bypass, or use the battery for any other purpose . – Keep the battery away from children or animals, open flames and liquids and do not expose it to temperatures higher than 50° C . In addition, observe the information on caring for the battery in these operating instructions .
Page 24
Safety Instructions – The device is not a toy . Keep the device, accessories and packaging materials away from children and pets to prevent accidents and suffocation . – Provide adequate ventilation during operation . Never cover the device . –...
Precautions – Fully charge the battery, then disconnect the USB-C cable . – If the product has not been used for a long period of time, charge the battery before using it again . – To extend the battery life, you should charge the battery at least every three months .
Product Overview Magnets USB-C input Select button Setting buttons On/off/mode button Display (OLED) ¼“ thread *Note that the adhesion of the magnets depends on the surface structure .
On/off/mode button [5] – With the on/off/mode button [5] you can switch the Rollei LUMIS I-Light RGB on or off with a long press . With a short press, you can change modes (CCT/color temperature mode, RGB mode or effects mode) .
Page 29
Operation RGB Mode Battery level RGB color value Saturation Brightness – In RGB mode, press the select button [3] to switch between the RGB color value, saturation and brightness settings . The values can be adjusted via the setting buttons [4] . Pressing increases the value, pressing decreases it .
Page 30
Operation Effects Mode Battery level Effect Brightness – In effects mode, press the select button [3] to switch between the settings of the 20 effects and the bright- ness . The values can be adjusted via the setting buttons [4] . With the value is increased, with it is decreased or the effect is changed .
– When charging the Rollei LUMIS I-Light RGB, please use USB adapters with an output of DC 5 .0 V 2 .0 A . The Rollei LUMIS I-Light RGB supports charging via Quick Charger and USB Power Delivery (USB-PD) up to the above voltage .
Input DC 5 .0 V 2 .0 A Connections ¼“ thread Dimensions (LxWxH) 20 x 4 x 3,5 cm Weight 236 g Box content Rollei LUMIS I-Light RGB, mini tripod, USB-C cable (1 m) Subject to technical changes . ENGLISH...
Battery Warnings – Do not disassemble, hit or puncture the battery, be careful not to short-circuit the battery . Do not expose the battery to places with high temperatures . – Do not continue to use the battery if it leaks or expands .
Disposal Dispose of the packaging according to its type. Use the local possibilities for collecting paper, cardboard and other materials (applicable in the European Union and other European countries with systems for the separate collection of recyclable materials) . Devices that are marked with this symbol must not be disposed of with household waste! You are legally obliged to dispose of old devices separately from to dispose of...
Conformity Rollei GmbH & Co . KG hereby declares that the device ”Rollei LUMIS I-Light RGB“ complies with the following directives: 011/65/EU RoHS Directive 2014/30/EU EMC Directive The full text of the EU Declaration of Conformity is available at the following Internet address: www .rollei .com/egk/lumisilight...
Page 36
Rollei GmbH & Co . KG In de Tarpen 42 22848 Norderstedt Service Hotline: +49 40 270750277 /rollei .foto .de @rollei_de Item No .: 28603 www.rollei.de...
Need help?
Do you have a question about the LUMIS I-Light RGB and is the answer not in the manual?
Questions and answers