Advertisement
BEFORE YOU BEGIN
·
Please read these instructions carefully to
familiarize yourself with the required tools, materials,
and installation sequences. Follow the sections that
pertain to your particular installation. This will help
you avoid costly mistakes. In addition to proper
installation, read all operating and safety instructions.
·
All information is based on the latest product
information available at the time of publication.
Kohler China Ltd. reserves the right to make
changes in product characteristics, packaging, or
availability at any time without notice.
·
These instructions contain important care, cleaning,
and warranty information-
instructions for the consumer.
·
Please provide adequate available space for the
bath unit in accordance with rough-in. Arrange the
location of drain in advance.
IMPORTANT:
All installations must comply with council and local
authority by-laws. It is the responsibility of the installer
to ensure that the waste is made watertight by means
of silicone sealant or caulking compound.
NOTE: Bath can be installed after the wall is completed.
Bath drain supplies should be arranged preliminarily
according to the selected bath.
PRODUCT REQUIREMENTS
A. Summary Of Key Requirements
·
Observe all local plumbing codes.
·
Install the unit to a level subfloor.
B. Plumbing Specifications
If using a rim-mounted bath faucet, flexible connections
between the valves and spout may be required.
Confirm adequate mounting, connection
specified faucet for your installation.
C. Product Inspection
Uncrate and inspect bath for damage. All Kohler s
baths have been manufactured with sophisticated
craftsmanship. However, please inspect for any
possible damage that may have occurred in transit.
Leave all materials in the crate during construction to
prevent damage.
1108169-T01-A
please leave these
space
of
'
·
·
·
·
A.
·
·
B.
C.
368
201419
ESCALE
INSTALLATION INSTRUCTIONS
FREESTANDING ACRYLIC BATH
Copyright Kohler China Ltd., 2008
K-11344T
, 2008
Advertisement
Table of Contents
Related Manuals for Kohler Escale K-11344T
Summary of Contents for Kohler Escale K-11344T
- Page 1 Confirm adequate mounting, connection specified faucet for your installation. C. Product Inspection ’ Uncrate and inspect bath for damage. All Kohler s baths have been manufactured with sophisticated craftsmanship. However, please inspect for any possible damage that may have occurred in transit.
-
Page 2: Installation Requirements
NOTE: Damage occurred during transit shall not be covered by warranty. D. New or Replacement Installation Requirements This bath can be installed in new or existing bathrooms. For replacement: Remove the old bath, and remove enough old wall material and floor covering from the area to allow for installation. - Page 3 BEFORE INSTALLING UNIT A. Protect the Bath Unit Position a protective covering or similar material in the bottom of the unit. Be careful not to scratch the bath surface. INSTALL THE BATH A. Locate the bath in the proposed position 1.
-
Page 4: Plumbing Installation
The drain has been installed onto the bath before it leaves factory. Fill the bath with water before the bath is securely positioned so as to check the supply connections for leaks. Kohler Co. shall not be liable under its warranty or otherwise for damage caused by negligence. -
Page 5: Important Consumer Information
Remove and install the freestanding bath If the freestanding bath needs removing, please follow the steps below: Lift the bath levelly, now the guide pin could be freely pluged out of the guide bush. Then remove the removable nut on the drain tailpiece. This nut is removable.
Need help?
Do you have a question about the Escale K-11344T and is the answer not in the manual?
Questions and answers