Jumpers Setup; Connectors - ASROCK GE PRO-HT User Manual

2.7 Jumpers Setup

The illustration shows how jumpers are
setup. When the jumper cap is placed on
pins, the jumper is "SHORT". If no jumper
cap is placed on pins, the jumper is "OPEN".
The illustration shows a 3-pin jumper whose
pin1 and pin2 are "SHORT" when jumper cap
is placed on these 2 pins.
Jumper
PS2_USB_PWR1
(see p.6/p.7 item 22)
or USB wake up events.
Note:To select +5VSB, it requires 2 Amp and higher standby current provided
by power supply.
Clear CMOS
CLRCMOS1
(see p.6/p.7 item 17)
Note: These solder points allow you to clear the data in CMOS. The data in CMOS
includes system setup information such as system password, date, time,
and system setup parameters.

2.8 Connectors

Connector
FDD connector
(33-pin FLOPPY1)
(see p.6/p.7 item 10)
Note: Match the red marking on the floppy ribbon cable with Pin1.
Setting
1_2
+5V
solder points
Connectors are NOT jumpers. DO NOT place jumper
caps over these connectors.
Figure
FLOPPY1
Pin1
Description
Short pin2, pin3 to enable
2_3
+5VSB (standby) for PS/2
+5VSB
Description
To clear and reset the
system parameters to default
setup, please turn off the
computer and unplug the
power cord, then short the
solder points for more than
3 seconds by using metal
material, e.g., a paper clip.
Description
Red marking