Berrcom JXB-195 Instruction Manual page 8

is seen. If the device is determined not to be visually clean at the end of the cleaning step,
you should either repeat the relevant previous cleaning steps or safely dispose of the device
so that a visibly soiled device is not used again.
Disinfection:
1) Disinfect the thermometer casing and the probe for 30 seconds with a cotton swab or
non-dust cloth dipped in 75% ethanol.
2) Repeat the above steps at least 3 times, then wipe surface and probe dry with a clean
cloth, and wait about 1 minute for drying after disinfection process.
Note:
Ensure that no liquid enters the interior of the thermometer.

Never use abrasive cleaning agents, thinners, or benzene for cleaning, and never

immerse the thermometer in water or other cleaning liquids.
Take care not to scratch the surface of the probe lens and the display.

If the visual inspection identifies unacceptable deterioration such as corrosion,

discoloration, pitting, cracked, the device should not be further used and should be
discarded.
If the thermometer has been used in patients, please visually inspect the thermometer to

determine if there is stain or oil on the casing or probe after each use, and follow the
instruction of cleaning and disinfection to cleaning your thermometer.
Care and Maintenance:
Please clean the thermometer regularly, usually once a month.

If the probe tip is damaged, please contact the maintenance center.

If necessary, you can clean it properly according to the actual dirt of the product; if you

do not use this product for a long time (more than 2 months), replace all the batteries
take out.
Store the thermometer in a dry location free from dust and contamination and away from

direct sunlight.
Do not use other batteries than mentioned batteries, do not use rechargeable batteries,

do not throw in fire.
Do not expose the thermometer to sunlight or water.

Do not use the thermometer rudely. Dropping, crashing and severe shock will damage

the product
Calibration:
This thermometer is calibrated at the time of manufactured, If the thermometer is used
according to the instruction, periodic recalibration is not required. If at any time you question
the accuracy of the measurement, please contact the retailer immediately.
Don't attempt to modify or reassemble the thermometer.
The calibration operation of this product must have corresponding calibration equipment,
otherwise it cannot calibrate by itself.
8