Berrcom JXB-195 Instruction Manual page 5

compress on his or her forehead.
. Do NOT take an individual's temperature when there has been a significant change in
ambient conditions. Allow the device to adjust to the significant change in the ambient
temperature due to a change in environment for at least 30 minutes before taking the
measurement.
. Wait at least 3 to 5 seconds between measurements.
. We recommend that you take three measurements on the forehead. If the results of
the three measurements are different, use the one with the highest value.
VI. TURNING ON AND SETTING THE THERMOMETER
1. Turning on the device
Press the "On/Scan" button. The display will illuminate, and enter the standby mode and will
display "---°C" or "----°F". When then press the "On/Scan" button, will get the measuring
result in 1 second. But if there is no key to press, it will turn off in 30 seconds automatically.
2. Setting the MODE when the device is on
a. Press "MODE" button, if the screen display: Body...°C, it is "Body temperature mode".
b. Press "MODE" button again, if the screen display: Surface Temp...°C, it is "Surface
temperature mode".
c. Press "MODE" button again, if the screen display: Room...°C, it is "Room temperature
mode".
Note: The thermometer default is set to BODY temperature mode.
NOTE
THE SURFACE TEMPERATURE AND ROOM TEMPERATURE ARE NOT MEDICAL USE.
The surface temperature differs from the body temperature. To obtain the body temperature,
you should use the "body temperature mode".
Use the Surface Temperature Mode to measure the temperature of a baby-bottle/bath water
and the Room Temperature Mode to measure the room temperature.
3. Choosing the temperature unit
In the switch on state, press "MODE" button for 3 seconds, the screen will display "F1", then
press "MODE" button again, the screen will display "F4". Then press "MEM" button to select
Celsius "℃", press "On/Scan" button to select Fahrenheit "℉", by pressing "MODE" button to
confirm.
4. View previous measurement results
In the switch on state, press "MEM" button, which will then display the last temperature and
allow for a view of the last 32 measurements.
In the switch on state, press "MEM" button and hold for 5 seconds, and all data in memory
will be deleted. Then press "MEM" button again, the display will show "CLr".
5. High-temperature prompt function
Under the body temperature mode, if the measured body temperature is higher than or equal
5