Setting The Beep Tone; Maintenance - Aiwa CT-X410 YU Operating Instructions Manual

SETTING THE BEEP TONE

The unit is preset at the factory to beep each time
you press any button on the front panel except %,
z, f, or g (no beep with the Jog Dial). You
can mute this beeping by following the procedure
below.
1
With the unit off, press and hold SEL for
more than 2 seconds.
The "BEEP" indication appears.
2
Rotate the Jog Dial to select on or off.
The beep function is activated when the
"BEEP" indication appears with the audio
level indicator lit, and canceled when not
displayed.
Audio level indicator
3
Press and hold SEL for more than 2
seconds.
The unit turns off.
13
ENGLISH

MAINTENANCE

Cleaning the front panel
When the front panel is soiled, wipe the surface
with a soft, dry cloth.
Cleaning the tape head
Use a cleaning cassette to clean the playback
head and capstans approximately once a month.
If the head is dirty, the high tones may not be
reproduced properly.
Cleaning the connector
The connector on the reverse side of the front
panel needs to be cleaned occasionally. Wipe
the surface of the connector with a cotton swab
slightly moistened with alcohol.
CTX410(YU)-total-En-14