IDEAL 58-N-1 01 Series Setup And Mounting Manual

IDEAL Wireless Sensor System
Setup and Mounting Guide
Guide Overview
This guide is provided to help users get started using their IDEAL Wireless Sensor System quickly and efficiently. For detailed
instructions about the Gateway and network configuration. Please refer to user documents found on the following page:
http://www.idealwirelesssensors.com/support/
Configuring Sensors
It is easiest to configure all the sensors for a deployment at one time. After powering on the gateway and configuring the terminal
interface, using the S option, take each sensor and plug them into the gateway, one at a time. This will configure each sensor with
the gateway's network protocol settings; 2.4GHz systems – Comm Channel and Network ID; 915Mhz systems – Network ID ONLY.
To configure sensors, each sensor must be opened to expose the USB configuration port. To open the enclosure, there are 2 slots
on the right side. The slots are just large enough for a flat-head screwdriver. Insert the screwdriver, applying light pressure to the
tab, and then twist the screwdriver to release the tab. CAUTION: Excessive opening and closing of enclosure could result in
broken tabs. Use care when opening and closing, and only open enclosure when necessary.
During configuration each sensor is assigned an ID that is activated in the gateway. This number should be written on the FCC
58-N-1x01
label inside the sensor enclosure. You can also write the network protocol settings for more detail (2.4GHz systems – Comm
Channel and Network ID; 915Mhz systems – Network ID). Reattach the sensor back when configuration is complete.
USB Configuration
Port
idealwirelesssensors.com
58-N-1202-C02-R
Contains:
FCC ID: OA3MRF24J40MA
IC: 7693A-24J40MA
Node ID#
Example Sensor Label
Screwdriver slots