GENLED ACOLYTE ARMOR Series Installation Manual

MINI
1. Tilt the fixture top to one side and position the fixture at the
desired location.
3. Rotate the fixture in the opposite direction and fasten the
screws on the other side of the tiltable stand.
NANO
1. Tilt the fixture top to one side and position the fixture at the
desired location.
3. Tilt the fixture top to the other side and fasten screws through
second set of screw holes on the tiltable stands (same as Step 2).
Acolyte | Architectural Lighting Solutions
2. Secure the fixture in place by fastening the screws through the
screw holes on one side of the tiltable stand.
4. Connect input cable to the power supply. Daisy-chain the
connector on the opposite end to the next fixture if desired.
2. Fasten screws through the screw holes on the tiltable stands.
4. Connect to power supply and to additional fixture if desire to
complete the installation.
Acolyte is a quality division of GENLED
M I N I / N A N O I N S T A L L A T I O N G U I D E
Tech Support: (+1) 212 629 6830 *301
Max screw diameter
0.185" (4.7 mm)
2-pin IP67 connector to
additional fixture
24V DC bare wire
to remote driver
Tiltable Stand
Max screw diameter
0.185" (4.7 mm)
2-pin IP67 connector
to additional fixture
24V DC bare wire
to remote driver
Brands™ | www.GENLEDBrands.com/Home/Acolyte |
A R M O R S E R I E S
Tech@GENLEDBrands.com
Tiltable Stand
Page 1