GENLED acolyte RIBBONLYTE Manual

R I B B O N L Y T E C U T T I N G & S O L D E R I N G

G U I D E

U.S. TECHNICAL SUPPORT

(+1) 212 629 6830 *301

Tech@GENLEDBrands.com

U.S. PRICING & SALES SUPPORT

(+1) 212 629 6830 *300

Sales-US@GENLEDBrands.com

U.S. CUSTOMER SERVICE

(+1) 212 629 6830 *304

CustomerService@GENLEDBrands.com

GENLED Acolyte

| Architectural Lighting Solutions

GENLED Acolyte

is a quality division of GENLED

Brands™

| www.GENLEDBrands.com/Acolyte |

Page 1

Table of Contents

Need help?

Do you have a question about the acolyte RIBBONLYTE and is the answer not in the manual?

Page 1 U.S. PRICING & SALES SUPPORT (+1) 212 629 6830 *300 Sales-US@GENLEDBrands.com U.S. CUSTOMER SERVICE (+1) 212 629 6830 *304 CustomerService@GENLEDBrands.com ® ® GENLED Acolyte | Architectural Lighting Solutions GENLED Acolyte is a quality division of GENLED Brands™ | www.GENLEDBrands.com/Acolyte | Page 1...
Page 2 PREPARING WIRE FOR TINNING/SOLDERING Twist ends of wire to prepare for tinning/soldering. Create a thin wire surface with no frayed wires. ® ® GENLED Acolyte | Architectural Lighting Solutions GENLED Acolyte is a quality division of GENLED Brands™ | www.GENLEDBrands.com/Acolyte | Page 2...
Page 3 Trim the wire leads to the correct length. This length should be as short as possible to allow soldering to the pads. Any contact between adjacent leads could result in damage to your components. ® ® GENLED Acolyte | Architectural Lighting Solutions GENLED Acolyte is a quality division of GENLED Brands™ | www.GENLEDBrands.com/Acolyte | Page 3...
Page 4 Soldering is easiest using clamps to hold the leads against the tinned solder pads. Apply solder to the tip of the soldering iron and solder the leads to the RibbonLyte. This is what correctly soldered RibbonLyte looks like. REV.07DEC2020 ® ® GENLED Acolyte | Architectural Lighting Solutions GENLED Acolyte is a quality division of GENLED Brands™ | www.GENLEDBrands.com/Acolyte | Page 4...