Download Print this page
Bunn JDF-2 NCV Programming Manual

Bunn JDF-2 NCV Programming Manual

Programming lemonade in the juice dispenser
Hide thumbs Also See for JDF-2 NCV:

Advertisement

Quick Links

Programming Lemonade in the BUNN Juice
RECOMMEND THAT TWO PEOPLE CONDUCT PROGRAMMING: ONE PERSON
READS INSTRUCTIONS WHILE THE SECOND PERSON PERFORMS THE TASKS
Getting Started
The following Getting Started steps should be completed as soon as possible to
allow sufficient time for the juice machine to be repaired and/or any parts to be
replaced, if necessary BEFORE All Store Selling Date.
1.
Verify restaurant has the minimum required parts for each BUNN
juice machine (illustration 1) and that all parts are clean in good
working condition.
2. Verify both sides of the machine are working. If you are not
currently using both sides for OJ, the easiest way to do this is to
move the drawer holding OJ concentrate to opposite position (e.g.
Top to Bottom).
Program Lemonade
1.
Load a bag of lemonade into the machine (illustration 3). Dispense
a few times to confirm the product is dispensing. For optimal
performance, we recommend placing lemonade in the bottom
tray.
2. Gather supplies (illustration 2):
a. Calibration cup (sent to restaurant with training materials)
b. Flat blade screwdriver
c. Small clear cup to place screws in
3.
Remove the drip tray and the splash panel. Splash panel is held in
place with 2 screws at the bottom. Put the screws in a safe place;
they will not be replaced until all programming steps are complete.
4.
Locate the button under Program. Push it to the left to enter the
programming mode. Display on door will read "PRO."
5.
Put the splash panel in place (without replacing the screws).
Replace the drip tray (the drip tray will keep the splash panel in
place). NOTE: This step is required to prevent product splashing
onto the control panel and damaging the machine.
6.
Place the calibration cup on the drip tray under the nozzle on the
side that lemonade will dispense from. Press and release the small
portion size button 3 times. Measure and record the amount of
water that dispenses here
7.
Press and release the small button 6 times. Measure and record
the amount of lemonade that dispenses here
product.
Dispenser
Discard water.
oz
oz
Illustration 2
Discard
Illustration 1
Illustration 3
Program Switch
1

Advertisement

loading
Need help?

Need help?

Do you have a question about the JDF-2 NCV and is the answer not in the manual?

Questions and answers

Summary of Contents for Bunn JDF-2 NCV

  • Page 1 BEFORE All Store Selling Date. Verify restaurant has the minimum required parts for each BUNN juice machine (illustration 1) and that all parts are clean in good working condition.
  • Page 2 Refer to the Ratio Target Chart below. If the Target Total Volume (collected in step 5) matches the corresponding Water Only Volume column (collected in step 4), proceed to step 10. Lemonade Ratio Target Table Approximate water amount Adjust finished product amount dispensed during test as close to possible to target 9.00 –...
  • Page 3 Setting Portion Controls for Lemonade in BUNN RECOMMEND THAT TWO PEOPLE CONDUCT PROGRAMMING: ONE PERSON READS INSTRUCTIONS WHILE THE SECOND PERSON PERFORMS THE TASKS 1. On the side that will dispense lemonade, press and hold the small portion size button until you hear 3 beeps, then release. Display on door will read “POR.”...
Save PDF