ASROCK 770DE3L User Manual page 40

HT Bus Width
This feature allows you selecting Hyper-Transport bus width. Configura-
tion options: [Auto], [8 Bit] and [16 Bit].
Memory Configuration
Memory Clock
This item can be set by the code using [Auto]. You can set one of the
standard values as listed: [400MHz DDR3_800], [533MHz DDR3_1066],
[667MHz DDR3_1333] and [800MHz DDR3_1600].
DRAM Voltage
Use this to select DRAM voltage. Configuration options: [Auto], [1.30V] to
[2.05V]. The default value is [Auto].
Memory Timing
BIOS SETUP UTILITY
OC Tweaker
Memory Configuration
[Unganged]
Memory Controller Mode
[Disabled]
Power Down Enable
[Auto]
Bank Interleaving
[HASH 2]
Channel Interleaving
CAS Latency (CL) [Auto]
9
TRCD [Auto]
12
TRP [Auto]
12
TRAS [Auto]
30
TRTP [Auto]
5
TRRD [Auto]
4
TWTR [Auto]
5
TWR [Auto]
10
TRC [Auto]
33
TRWTWB 8 [Auto]
TRWTTO [Auto]
7
[Auto]
TWRRD 2
v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.
Memory Controller Mode
It allows you to adjust the memory controller mode. Configuration options:
[Unganged] and [Ganged]. The default value is [Unganged].
Power Down Enable
Use this item to enable or disable DDR power down mode.
Bank Interleaving
Interleaving allows memory accesses to be spread out over banks on the
same node, or accross nodes, decreasing access contention.
Channel Interleaving
It allows you to enable Channel Memory Interleaving. Configuration options:
[Disabled], [Address bits 6], [Address bits 12], [HASH 1] and [HASH 2]. The
default value is [HASH 2].
CAS Latency (CL)
Use this item to adjust the means of memory accessing. Configuration
options: [Auto], [4CLK] to [12CLK]. The default value is [Auto].
Select Screen Select Screen
Select Item Select Item
+- +- Change Option Change Option
F1 F1 General Help General Help
F9 F9 Load Defaults Load Defaults
F10 F10 Save and Exit Save and Exit
ESC ESC Exit Exit
4 0 4 0 4 0 4 0 4 0