Basic Operation, Audio And Clock Adjustment - Aiwa CDC-Z127 Operating Instructions Manual

BASIC OPERATION,
AUDIO AND CLOCK
ADJUSTMENT
PWR/MUTE SEL
AUDIO CONTROL
i/k
DISP SRC
BAND
Turning the unit on/off
• Press PWR/MUTE to turn on the unit. The unit also
turns on when you insert a CD.
• Press and hold PWR/MUTE until the unit turns off.
Note
Most operations described in this manual require the
unit to be turned on before starting the operation,
unless explicitly stated otherwise.
Changing the source mode
1
Press SRC.
Pressing SRC cycles through source modes in the
following order:
FM1 (FM2/FM3/AM1/AM2)
* "CD" does not appear in the display when there is no
CD in the unit.
Adjusting the volume
1
Turn AUDIO CONTROL.
VOL (volume) indicator flashes.
Muting the sound
1
Press PWR/MUTE briefly.
MUTE indicator flashes.
To restore volume, briefly press PWR/MUTE again.
Adjusting sound
You can select the following modes for adjusting sound
depending on the music you listen to: BASS (low
frequencies), TRE (high frequencies), BAL (left/right),
FAD (front/ rear) and H-BASS (high bass).
1
2
Note
Adjust the level or select on/off within 5 seconds, or the
selected mode will return to previous state.
Aligning the source levels
(Source Level Adjuster)
Volume may vary each time you change the source
mode. In this case, you can align each source mode's
volume to almost the same level.
1
2
3
Note
Adjust the level within 5 seconds, or the selected mode
will be canceled.
Restoring the factory settings
1
2
CD* AUX
Note
You can restore the factory settings only for VOL,
BASS, TRE, BAL, FAD, and H-BASS, and aligned
source volume levels.
Muting button beep sounds
1
2
3
4
Press SEL repeatedly to select the mode to be
adjusted.
Pressing SEL cycles through the modes. The
selected mode's indicator flashes.
Turn AUDIO CONTROL to increase/decrease the
level or to select on/off for the selected mode.
Press SRC or BAND repeatedly to select the desired
mode.
Press DISP while pressing SEL.
"LA 0" appears in the display.
Turn AUDIO CONTROL to adjust the level.
Turn off the unit.
Press and hold DISP until "LA --" appears in the
display.
Turn off the unit.
Press and hold SEL until "bEEP" appears in the
display.
Turn AUDIO CONTROL to select on (level indicators
appear) or off (level indicators disappear).
Press SEL.
2 2
ENGLISH ENGLISH