AUDIO AND CLOCK
P W R I A T
sELJog dial (PUSH-SOURCE)
Turning the unit onloft
turn on the unit. The unit also turns
Press and hold PWWAlT until the unit turns
on when you insert a CD.
Most operationsdescribed in this manual requirethe
unit to be turned on before starting the operation,
unless explicitly stated otherwise.
Chanaina the source mode
source modes in the following order:
" C D does not appear in the display when there is no
CD in the unit.
Adiustina the volume
VOLUME indicator appears.
Muting the sound
Press PWFJAn briefly.
A T indicator flashes.
To restore volume, briefly press PWWATT again.
Press SEL repeatedly to select the mode to be
Pressing SEL cycles through the modes. The
selected mode's indicator appears.
dial to increase/decrease the level or to
select onloff for the selected mode.
Adjust the level or select on/off within
seconds, or the
selected mode will return to previous state.
Alianina the source levels
(Source Level Adjuster)
Volume may vary each time you change the source
mode. In this case, you can align each source mode's
volume to almost the same level.
dial (PUSH-SOURCE) or TU (TUNER)
repeatedly to select the desired mode.
Press DSPL while pressing SEL.
appears on the display.
dial to adjust the level.
Adjust the level within
seconds, or the selected mode
will be canceled.
Restoring the factory settings
Turn off the unit.
Press and hold DSPL until "LA
appears on the
You can restore the factory settings only for VOL,
BASS, TRE, BAL, FAD, and H-BASS, and aligned
source volume levels.
Setting the beep tone
Turn off the unit.
Press and hold SEL until "bEEP appears on the
dial to select on (level indicators appear)
(level indicators disappear).
You can select the following modes for adjusting sound
depending on the music you listen
frequencies), TRE (high frequencies), BAL (leftlright),
FAD (fronil rear) and H-BASS (high bass).