Do not allow children to play with Do not let children play with packaging or operate the appliance. and its parts. There is a risk of suffo- Keep children away from detergents cation from collapsible boxes and film. and rinse aid. These may cause...
Therefore: Pull out the mains plug, sever Programme buttons ** and dispose of the power cord. Destroy Digital display the door lock so that the door can no Display “Check water supply” longer be closed. Salt refill indicator Rinse-aid refill indicator...
Setting otherwise white limescale will be deposited on the utensils and inner Deutsch L:01 container. English L:02 Tap water above 7_ dH (from set value Français L:03 ) must be softened. Nederlands L:04 The water is softened with salt Italiano...
Then add dishwasher salt (not table salt or tablets). The water is displaced and runs out. As soon as the salt refill indicator on the fascia is lit, top up the salt. * depending on model Using detergents with salt component...
Proceed as described under “Setting water softening system” and set the Combined detergents with rinse-aid com- ponent may be used up to a water hard- value to ness of 21 _dH (37 _fH, 26 _Clarke, The water softening system and salt 3,7 mmol/l) only.
START button until on a tendency to discolour and fade during the digital display is indicated the wash cycle. Even some types of glass Release both buttons. (e.g. crystal glass objects) may turn cloudy The LED for button A flashes and after many wash cycles.
D does not obstruct rotation of the two spray arms Very small utensils should not be washed in the machine, as they may fall out of the baskets. Unloading the dishwasher To prevent water from dripping off the...
Separately arranged The height of the upper utensils basket utensils are easier to remove after can be adjusted in 3 stages to create more washing. space either in the upper or lower basket. The drawer can be taken out.
To raise the basket, hold the basket on preset values for water hardness and the sides of the upper edge and lift it amount of rinse-aid. As soon as combined detergent Before re-inserting the basket again,...
Close the cover on the detergent have full cleaning effect due to different dispenser by sliding it up until the lock dissolving properties and there may engages without difficulty. even be undissolved detergent residue.
Overview of programmes The max. possible number of programmes is illustrated in this overview. The corresponding programmes for your appliance can be found on the fascia. Programme Type of utensils Programme sequence Possible and soiling additional options Auto 65°–75° Pots, utensils...
Half load * The Aqua sensor is used according to the programme. If the Aqua sensor is active, If you have only a few items to wash (e.g. “clean” rinsing water can be transferred to glasses, cups, plates), you can switch to the next rinse bath and water consumption “half load”.
To delete timer programming, press e.g. glass protection system is active. + or – button until If you would no longer like to have this is indicated on the digital display additional information displayed, proceed You can change your programme as follows.
To change the setting, Terminating the programme press programme button C . (Reset) Each time the button is pressed, the set Open the door. value increases by one level; when the Press START button value of has been reached, the approx 3 sec.
ON/OFF switch is switched on or off. This saves time and prevents problems. When the door is closed or ajar, the light Overall condition is off. of the machine Open the door.
The filters keep large foreign objects Limescale and contaminants in the rinsing water may block nozzles and bearings on in the rinsing water away from the pump. the spray arms These foreign objects may occasionally block the filters. Check outlet nozzles on the spray arms The filter system consists of a coarse filter, for blockages.
Scoop out water, use a sponge if required. Warning Using a spoon, prise off pump cover If an error code (E:01 to E:30) is indicated (as illustrated) until it clicks, then grip on the digital display , always the cover by the lug and first pull it...
Door cannot be closed. Water is left in the appliance at the end of the programme. Door lock has been activated. To reset, close the door with (E24) Waste water hose is greater force. blocked or kinked. (E25) Waste water pump ...
Dull, discoloured glasses, noises film cannot be washed off. Caused by the installation of the Unsuitable detergent. water line and has no effect on the Glasses not dishwasher-proof. function of the machine. Remedial Streaks on glasses and cutlery, action is not possible.
Customer service Installation If you are unable to rectify the fault, please The dishwasher must be connected contact your customer service. correctly, otherwise it will not function Your nearest customer service centre can properly. The specifications for the inlet be found in the customer service list.
Connect the appliance to an alternating Empty the dishwasher and secure current only, ranging from 220 V to loose parts. 240 V and 50 Hz or 60 Hz via a correctly Drain the appliance according to the installed socket with protective earth following steps: conductor.
Please dispose of the individual parts separated according to type. Please ask your dealer or inquire at your local authority about current means of disposal. Packaging All plastic parts of the appliance are identified with internationally standardised abbreviations (e.g.
To do this, remove the top basket and insert the spray head as illustrated in the diagram. To ensure that the spray jet can reach all parts, arrange the baking sheets as illustrated (max. 4 baking sheets and 2 grilles).
Page 29
AQUA STOP guarantee To ensure water damage protection, the appliance must be connected to the power supply. Neff GmbH Carl-Wery-Straße 34 81739 München To contact us directly, use the tel. no or fax no. in the enclosed customer service list.