Remaining Running Time Display; Display Window; Timer Programming; End Of Programme - NEFF S41T69N0UK Operating Instructions Manual

en

Remaining running time display

When the programme is selected, the
remaining running time of the programme
is indicated on the digital display
The running time is determined during the
programme by the water temperature, the
number of utensils as well as the degree
of soiling and may vary (depending on the
selected programme).

Display window

Apart from information on the programme
sequence, the display window
indicates additional information on
e.g. glass protection system is active.
If you would no longer like to have this
additional information displayed, proceed
as follows.
Open the door.
Switch on ON/OFF switch
Hold down programme button A
and press START button
the digital display
Release both buttons.
The LED for button A flashes and
the digital display displays the factory
setting .
Press programme button A until the
factory set value
the digital display
To change the setting,
By pressing the C button, you can
switch the onboard computer
(additional programme information)
off or on
Press START button
The set value is saved.
Close the door.
16
.
3
also
12
.
1
until on
10
is indicated.
is indicated on
.
3
.
.
10

Timer programming

You can delay the start of the programme
in 1-hour steps up to 24 hours.
Open the door.
Switch on ON/OFF switch
Press + button until the timer
8
programming display
Press + or – button until the
8
displayed time corresponds with your
requirements.
Press START button
programming is activated.
To delete timer programming, press
the + or – button until
8
is indicated on the digital display
You can change your programme
selection at any time until the
programme starts.
Close the door.

End of programme

The programme has ended when the
value is indicated on the numerical
display .
3
The end of the programme is also
indicated by an acoustic signal.
This function can be changed as follows:
Open the door.
Switch on ON/OFF switch
Hold down programme button A
and press START button
the digital display
Release both buttons.
The LED for button A flashes and the
digital display displays the factory
setting .
Press programme button A until the
factory set value
the digital display .
.
1
jumps to .
7
, timer
10
.
7
.
1
until on
10
is indicated.
is indicated on