Diagrams of the control panel and the power supply. Pull out the mains plug interior of the appliance can be found in or switch off the fuse. Turn off the tap. the envelope at the front. Disposal Individual positions are referred to in the text.
from : to : Salt is not required at the set value : – Find out about the hardness value of your tap water. Your water utility company will help you with this. – Set value can be found in the water hardness table.
You will destroy the water The water is displaced and runs out. softening system. As soon as the salt refill indicator h on – To prevent corrosion, always refill with the fascia is lit, top up the salt. salt immediately before switching on the appliance.
. Please set rinse aid on As soon as the rinse-aid refill indicator ` to obtain very good drying results is lit on the fascia, there is still a rinse-aid is already set in factory). reserve of 1 – 2 rinsing processes. Refill Change this setting, only if streaks (select with rinse aid.
Very small utensils should not be washed wash cycle. Even some types of glass in the machine, as they may fall out of the (e.g. crystal glass objects) may turn cloudy baskets. after many wash cycles.
* Depending on the model, a 3-fold height adjustment is possible. To do this, first place the etagere vertically and pull up, then place at a slight angle, push down to the required height (1, 2, or 3) and snap into place.
Small accessories holder * * depending on model Light-weight plastic accessories, e.g. cups, Adjusting the height of the lids, etc. can be held securely in the small basket * accessories holder. * depending on model If required, the height of the upper utensils basket 1"...
Top basket with side levers Detergent – Pull out the top basket 1" out. – To lower the basket, press in the left You can use tablets as well as powder and then the right lever on the outside or liquid detergents for dishwashers, but of the basket.
ã= dispenser by sliding it up until the lock Warnings engages without difficulty. – Do not place small parts for washing in the tablet collecting tray 12; this prevents the tablet from dissolving evenly. – If you want to add more utensils after...
Page 14
– If programmes are short, tablets may not have full cleaning effect due to different dissolving properties and there may even be undissolved detergent residue. It is recommended to use washing powder for these programmes.
Overview of programmes The max. possible number of programmes is illustrated in this overview. The corresponding programmes for your appliance can be found on the fascia. Type of utensils Type of soiling Programme Possible additional Programme sequence options Prerinse very adhesive burned- ±...
If the Aqua sensor is active, Half load * “clean” rinsing water can be transferred to If you have only a few items to wash (e.g. the next rinse bath and water consumption glasses, cups, plates), you can switch to can be reduced by 3–6 litres.
Short time after the end of the programme: value : is indicated on the numerical – Switch off ON/OFF switch (. display H. – Turn off the tap (not applicable if Aqua- Stop fitted). – Remove the utensils when they have cooled down.
Otherwise, expansion (pressure) may cause the appliance door to Change the setting as follows: spring open or water to run out of the – By rotating the programme selector appliance. 8, you can switch intensive drying – To continue the programme, switch on...
The manufacturer is not liable for any consequential damage. Regularly wipe the front of the appliance and fascia with a damp cloth; water and a little washing up liquid are adequate. Do not use sponges with a rough surface or abrasive detergents, as these could scratch the surfaces.
Abort programme function (Reset). (See chapter entitled “Dishwashing”) ã= Warning If on the digital display H an error code to : ), always disconnect the appliance from the power supply and then turn off the tap. You can rectify certain faults yourself (see...
– Spray arm blocked. (as illustrated) until it clicks, then grip The door is difficult to open. * the cover by the lug and first pull it – Child-proof lock is activated. The upwards until it resists and then pull it deactivation instructions are at the out forwards.
: ) or – Waste water pump blocked. implement the “Reset” function. – Top basket on right and left not set to Error code : same height. – Filters 1R are soiled or blocked. Tea or lipstick residue is not completely Refill indicator for salt h and/or rinse- removed.
When calling , please quote the appliance number (1) and the production date – No/too little rinse aid. (FD = 2) which can be found on the rating – No/too little special salt. plate 92 on the appliance door. – Water softening system set to the wrong value.
Safety instructions ã= Warning – Install and connect the appliance If the appliance is not in a cavity and a according to the installation and side panel is accessible, the door hinge assembly instructions. area must be covered at the side for –...
Water temperature: secured to prevent it from overturning, cold water preferred; hot water max. e.g. by screwing it to the wall or by temperature 60 °C. installing it under a continuous worktop which is screwed to adjacent cupboards.
It is recommended to have a water – Use only a residual current operated temperature (temperature of the incoming circuit-breaker which features the water) of at least 40 °C and no more than symbol ‚. Only this extension 60 °C. guarantees compliance with the It is not recommended to connect currently valid regulations.
Protection against frost – WEEE. The guideline specifies If the appliance is in a room where there is the framework for an EU-wide valid a risk of frost (e.g. holiday home), empty return and re-use of old the appliance completely (see appliances.
Need help?
Do you have a question about the S41E50N0GB and is the answer not in the manual?
Questions and answers