Selecting Language; Water Softening System; Set - NEFF S41T69N0UK Operating Instructions Manual

en

Selecting language

The language in the display window
can be set from
is the factory setting.
Language
Deutsch
English
Français
Nederlands
Italiano
ÅËËÇÍÉÊÁ
Español
Português
Svenska
Norsk
Suomi
Dansk
Türkçe
PYCCŽÅœ
Polski
Èeš.
Magyar
Croatian
Slovenian
To change the language:
Open the door.
Switch on ON/OFF switch
Hold down programme button
and press START button
digital display
3
Release both buttons.
Press programme button
the factory set value
on the digital display
"Deutsch" is indicated in the display
window .
12
Press programme button
Each time the button is pressed,
the set value increases by 1; after
, the setting goes back to
Press START button
The set value is saved.
Close the door.
6
12
to . "Deutsch"
Setting
L:01
L:02
L:03
L:04
L:05
L:06
L:07
L:08
L:09
L:10
L:11
L:12
L:13
L:14
L:15
L:16
L:17
L:18
L:19
.
1
A
until the
10
is indicated.
until
A
is indicated
.
3
.
C
.
.
10

Water softening system

To ensure good washing results,
the dishwasher requires soft water,
i.e. containing low amounts of lime,
otherwise white limescale will be
deposited on the utensils and inner
container.
Tap water above 7_ dH (from set value
) must be softened.
The water is softened with salt
(regeneration salt) in the water softening
system of the dishwasher.
The setting and therefore the required
amount of salt depends on the degree
of hardness of your tap water (see table).

Set

The amount of salt dispensed can be set
from to .
Sal is not required at the set value
Find out about the hardness value
of your tap water. Your water supply
company will assist you.
Set value can be found in the water
hardness table.
Open the door.
Switch on ON/OFF switch
Hold down programme button A
and press START button
the digital display is indicated
Release both buttons.
The LED for button A flashes and
the digital display displays the factory
setting .
To change the setting,
press programme button C .
Each time the button is pressed, the set
value increases by one level; when the
value of has been reached,
the display jumps back to
Press START button
The chosen setting has now been
stored.
Close the door.
.
.
1
until on
10
.
(off).
.
10