DW Windsor DAYTONA 450 Installation Instruction

Installation Instruction
IMPORTANT
• DISCONNECT ELECTRICAL SUPPLY BEFORE INSTALLATION OR SERVICING.
• THIS PRODUCT MUST BE EARTHED.
• THIS PRODUCT IS DESIGNED TO OPERATE OUTDOORS.
• THIS PRODUCT CONTAINS A LIGHT SOURCE OF ENERGY EFFICIENCY C TO F. THIS IS DEPENDANT ON PRODUCT DRIVE CURRENT,
LED COLOUR TEMPERATURE & OPTIC.
• DO NOT STARE AT THE OPERATING LIGHT SOURCE.
• PERSONNEL TO WEAR PROTECTIVE SAFETY GLASSES COMPLIANT WITH EN166 1F/EN169-5 WHEN COMMISSIONING OR
MAINTAINING THIS PRODUCT.
• BASIC INSULATION IS PROVIDED BETWEEN POWER & DALI.
• ALWAYS MAINTAIN BASIC INSULATION BETWEEN LOW VOLTAGE SUPPLY AND CONTROL.
• LEDS CONTAINED WITHIN THIS LUMINAIRE SHALL ONLY BE REPLACED BY THE MANUFACTURER, THEIR SERVICE AGENT OR
SIMILAR QUALIFIED PERSON.
• THE LUMINAIRE SHOULD BE POSITIONED SO THAT PROLONGED STARING INTO THE LUMINAIRE AT A DISTANCE CLOSER
THAN 2.7 METERS IS NOT EXPECTED.
PRODUCT DETAILS
DAYTONA
450
WINDAGE (m 2 )
0.043
8.5 kg
WEIGHT (kg)
A (mm) 460
B (mm) 582
C (mm) 572
D (mm) 170
E (mm) 88
* IP66 - FOR GEAR COMPARTMENT & LIGHT ENGINE
IP65 - CONTROLS & PHOTOCELLS
** IK10 FOR POLYCARBONATE LENS VERSION
TOOLS REQUIRED
Tools not supplied unless otherwise stated.
TORQUE WRENCH
1
T20
5
DW Windsor
Pindar Road, Hoddesdon, Hertfordshire, EN11 ODX
T: +44 (0) 1992 474600 | E: info@dwwindsor.com
dwwindsor.com
DAYTONA
500
0.065
13.5 kg
580
700
690
193
110
2
SCREWDRIVER
T25
Sheet 1 of 4
IP66* IK08**
A
SLOT HEAD
DAYTONA
450 & 500
10/630/06 REV B
B
C
24mm A/F
3
SPANNER
24
D
E